Your cart is empty.
Your cart is empty.Awileyone
2025-08-26 16:55:39
I picked up this circuit breaker for my boat, and so far, it’s been working great. The manual reset switch is super easy to use, and the waterproof design is a big plus for handling marine conditions. Installing it was straightforward, and it fit into my setup without any issues.The quality feels solid, and it’s been reliable so far. It’s nice knowing my electrical system has some extra protection against overcurrent problems. Overall, it’s a good addition and gives me some peace of mind out on the water.
kylar
2025-08-16 19:39:45
work good
Schmedved
2025-08-03 15:29:23
This is perfect for isolating all of my DC lights and accessories off from the rest of the circuit. It seems to eliminate the chance of parasitic drain on your system. And when you are done, press the button and the breaker trips and it is all off. I like that it is water proof. The quality seems really good and I was able to tighten it really good without fear of it cracking - as it should be.
Jen Rose
2025-05-26 18:03:45
Very good quality breaker that fits where it needed to. Good sized and easy to install. Functional and doesn’t get hot this is a good breaker and holds up well. Good value.
deedee212
2025-04-13 11:15:10
Before someone thinks it, I did NOT overtighten as I didn't have a chance to. It broke as I turned socket one turn past handtight. I make both AC/DC electrical connections for a living as I am a master electrician. Connection can not be just hand tight and 1 turn of rachet shouldn't crack plastic and expose the bus that connects fuse. Im 1 week past return window so I didn't bother to contact company. I just bought the LUG version with allen/hex set screw which also has small plastic covers which will be safer. Using this to tun 3000W inverter in workvan.
Eric Mortensen
2025-03-28 20:00:54
This 250 amp circuit breaker was installed with a Renogy 2000 W inverter and lithium batteries to run my 1500 watt microwave in an RV trailer. After about three minutes runtime, the circuit breaker would consistently trip even though it was using about half the rated amperage of the circuit breaker. I replaced it with a LiTime circuit breaker of the same amp rating (much better quality) and have not had any problems since.7/22/25 I have had a very quick response from the seller and positive results. They have given a full refund. Therefore I have put the star rating up to three.
Courtney
2025-03-13 11:46:14
Solidly built, controls move smoothly. My only problem is the studs seem undersized for a 250 amp service. Other than that, this is great.
Black Iron
2025-02-19 17:25:40
Decent circuit breaker, but this is not a fuse holder like the description says. Rated at 250A, the studs are small for such a high amperage. This was installed as part of the "BIG 3" upgraded wiring as a circuit protection from the alternator to the battery. The studs are smaller than the alternator output, which is about 5/16 or 8mm.
Recommended Products