Your cart is empty.
Your cart is empty.This easy bolt-on kit allows for better driveshaft angles reducing driveline vibration. Recommended for vehicles with 4.5" - 6.5" of suspension lift.
Kyle Dalton
2025-09-03 16:19:08
Easy install, works as supposed to
r/c Addictions
2025-07-13 13:05:18
Lifted my Cherokee and got a drive shaft vibration. This was way cheaper than a SYE.Make sure you get a good stud removal tool and propane torch
Customer
2025-06-27 11:29:54
As for ease of install forget it if your studs are rustwelded in place. I sheered both of mine and haven't been able to do anything about it sense. But for three months they have held up with just the rear two on and haven't shown any signs of losing torque spec either. Worth the money? Maybe. Is it cheaper and easier than a SYE? Absolutely.
thequara
2025-05-04 15:07:28
Works as described. If you are not ready to spend $ yet on SYE and new rear driveshaft, this is a good compromise. I have 96 XJ with 5" lift in the rear running 33x12.5x15s. With this drop kit I have smooth acceleration now, but still get some vibration and noise when off the gas and axle torques back against the driveline.
Logan
2025-02-20 11:09:02
Had vibrations after RC 3" lift install. This kit did a great job fixing that. However, installing this kit was a real pain. As soon as you remove the old bolts, even if only one side at a time like the instructions say, the holes will no longer line up easily. The transmission/transfer case will probably drift out of place. It shifted around an inch or so, and you have to fight tooth and nail for every millimeter you try to get back. It took me a couple hours of ratchet straps and wrestling stuff back into place. Overall, I'm very happy I installed this kit, as it solved the vibration issues. Just be aware that this one could potentially be a real pain in the neck.
Derick H.
2025-02-11 15:38:48
Installed 3†Rough Country Lift on 1999 Jeep XJ. Had some driveline vibrations. This kit solved that problem. Fairly easy to install. I had issues with the factory installed studs for the transmission crossmember. Ended up welding the nut to the stud and using a lot of PB blaster to break free. Once the old hardware is out of the way, install is fairly straightforward. Does help to have a buddy get the bolt holes lined back up.
Customer
2025-01-31 16:11:15
Fixed vibration, nice smooth ride, now the angles are correct again ,they said you don't need it with the 3 inch lift. I say not so, but do what works for you. I think this is a good kit for the money.
holland
2025-01-24 11:11:43
Take your time, easy install! Okay quality.
Recommended Products
