Your cart is empty.
Your cart is empty. LOOKING TO LIFT YOUR CAR AND NOT WANTING TO DAMAGE or SCRATCH THE UNDERSEAL?
THIS JACK PAD WILL FIT BETWEEN MOST JACKING POINTS AND HELP SUPPORT LIFTING.
Brand:Autoxbert
Material: Rubber
Size: As The Picture Shown
Package includes:
1pcs x Jack Pad
Feature:
Highly durable and resistant to damage, it will keep the chassis rails from getting pinched, bent, and broken.
The slot helps you to make sure you lift from the centre of the pad and prevent slipping.
Great for DIY vehicle maintenance or taking one with you in the car as some tire shops do not use these pads, and unfortunately bend your pinch/scrape off paint on the welds.
This can eventually lead to rust, save yourself the hassle with this simple product!
Note:
Please note these pads are for use with cars that use the seam weld as the lifting points.
Please allow a slight difference due to manual measurement.
Ringgard
2025-07-22 18:25:52
Basically a hockey puck with a trench cut in it. Works exactly as intended. fits perfectly on the pinch weld and takes the weight of the car without falling apart. A must buy for all my floor jacks.
Vasilios
2025-07-10 17:06:01
Overall this is a great product to fit on your floor jack and support/lift vehicles with pinch-welds. The rubber is not super durable and will see damage from use - perhaps a polyurethane product would be more resistant to frequent use. Overall for my purposes, this jack pad works well and gives the lifted vehicle additional support around the pinch welds. Even though it is a bit chewed up from several uses, it will last long enough to recoup the minimal investment.
Ismael Ramirez
2025-07-05 19:26:50
Looks and fits great in my jack. I tried to post photos but amazon is not letting me. Feels like a hard rubber and pretty thick. Haven't used it yet but I can't wait to.
Steve S.
2025-06-08 18:57:44
Works as described
Wreckin'Ball Duvall
2025-04-21 18:09:33
This is designed more for a professional, or commercial hydraulic jack. That's not really a slam on the product itself, but it definitely is way too big for mine. It seems like it's built well enough.
Larecia N Tucker
2025-03-19 11:52:16
Nowhere is it stated that it's new or used so I can't hold it against this company. But mine is used. Not much. It's 100% functional, as far as I can tell. But it was used...
brenda stewart
2025-02-10 18:30:07
Fit and finish is good. Should last many years.
john roush
2024-12-05 15:57:43
This does work but I recommend taping it to the jack so it stays on center since it doesn't have a recession on the back
Recommended Products
