Your cart is empty.
Your cart is empty.N0BAD
2025-07-26 15:56:55
These fit the front windows of my 2001 Chevy Silverado like a glove. I took the extra steps and took the door panels off, lifted the lower window seal. To do both windows only took about 45 minutes, and that includes the time it took to remove the door panels. I used a rewards card. I also put soapy water mix on the inside so I wouldn't scratch the tint. About the only problem I had is I didn't wipe the soap mix off the outside, and thought that it was on the inside so it took a bit of time before I realized my mistake. With this tint I didn't have to cut or trim anything. I wish I could give more stars, but this is a great product, and whenever I need more this will be my go to company
Jim L
2025-06-15 10:02:55
I dont generally complain but....I dont want anyone to have this experience. Got tint and being 2nd time i have did this figured it be a snap. Read directions (kinda hookey) and watched a brand specific video on install. The film on back, which is not marked, was crazy hard to separate. Took 30m to get it loose even with the supplied stickers. Then when separating the the tint from the film it felt like stretching it since it pulled really hard. Okay got it off. Went to pass side door. Did the soapy water etc. Fit was good but it too long so after getting 99% on glass trimmed the lowest point and fit was fine. BUT it would not set down on glass. Like it had been stretched out when peeling back off. Tried some heat and harder and softer squeegeeing and to no avail would the film adhere properly along the edge and in top 1/4 of glass. Like I said felt stretched. After 30-40 min I gave in and removed the tint so it would not be stuck looking so bad. So I went to the drivers side. Made triple sure everything was clean, wore my nitrile gloves and had warm soapy sprayer. Peeled film off, hard again, and set tint on soaped up window. The top and ack edges would not quite square up. it set down clearly better than the 1st side did but the 3 showing edges just would not line up. And it was def way longer on bottom. After 20m I decided this was not acceptable nor going to ever look right and prob peel since the tint would not fit clean enough on edges. I asked for a refund explaining my situation or even a new set to try. Nope, I dont have evidence of it not fitting. Like I was going to leave it on and let it dry looking hideous and not being able to open the windows. Just sick how they dont care at all about the quality of their product. All I wanted was a a "hey sorry, try another one.". But nope full "not us, thanks for your money.". Just be thoughtful if a Rvinyl product is flawed you have 0 chance of recourse. Thanks for reading.
Jerah
2025-05-05 13:27:28
buy it. this tint is great, the only thing that sucked was the plastic clear siding that you have to take off but eventually i got it. it did seem very thin to me but it looks awesome. the fit was great. instalation seemed to be good. bubble and wrinkle free!
john wood
2025-04-17 13:26:04
I ordered 20% I don’t think I got it but it worked fine
patrick
2025-02-26 17:58:11
This is quality tint, it’s a little expensive but TOTALLY worth the money considering that it was pre-cut.
Andy Stiner
2024-12-21 18:18:44
Didn't cover glass 100 percent
phillip smith
2024-12-18 17:13:21
5 stars all day. this tint is amazing quality! im forever sold on precut tint! it layed on easy and was a perfect fit! i will be purchasing again for my other vehicles.
Adam thueringer
2024-12-03 15:56:41
100% dissatisfied. Over cut did not fit was too big. Did not stick. Would not peel. I feel embarrassed I was ripped off by such junk. I feel like I should be refunded. And I was thinking about buying the vinyl wrap kit but I'm not so sure now. Depends on if customer service refunds me from such a horrible experience.
Recommended Products