Your cart is empty.
Your cart is empty.Product Description
Coolant Temperature Sensors
Brand Information
SCHNECKE
- Provider of Engine Coolant Temperature Sensor products to the worldwide OEM market and aftermarket.
- SCHNECKE offers complete Engine Coolant Temperature Sensor coverage for Asian, Domestic and European vehicles.
CAUSE FOR REPLACEMENT
- Check engine lamp illumination
- • No/erratic gauge operation
- • No/erratic cooling fan operation
- • Engine overheating
- • Rough idle
- • Engine hesitation
- • Poor fuel economy
- • Failed emissions test
PURPOSE
The engine coolant sensor determines the exact temperature of the engine coolant
FUNCTION
Sends an analog signal to the ECM to ensure proper air/fuel ratio along with proper operation of the cooling fan(s) and temperature gauge
POSITION
Located on the cylinder head, engine block, thermostat
housing or intake manifold
Langley’s
2025-07-30 17:35:38
I installed this in a 1988 Mustang GT. My temp gauge was not working. I installed this sender and now it works. Simple enough
V. Foley
2025-06-03 18:13:03
NOT CORRECT RESISTANCE VALUE FOR 4.0 LITRE EXPLORER
D.V.D
2025-06-01 15:51:19
Good
Rob W
2025-05-24 15:37:34
Part worked but, I had to change the connector because the terminal stud where the connector slides over was bigger than the factory sensor. Had to replace the connector before the part would work.. had to order connector so vehicle was down for a few days over a simple repair.
Customer
2025-05-07 09:54:41
Even Amazon check said it will fit to 1996 f250 7.5L, it didn't work. Thread is right but the electrical connector couldn't be connected. This has a black insulator, I need the one with green insulator that has a thin threaded stud.
Exodus
2025-04-01 18:19:14
Purchased this to replace the failing temp sensor in my 1992 4.0 Ranger.Thread pitch and fastener size was correct.Sensor plug was not- too big. I was already committed so I opened the stock sensor plug to make it work.The sensor electrode spins freely in the base housing. We'll see if it leaks.I'd recommend anything else. Dont modify your vehicle for a crappy sensor.
Andrew Finn
2025-02-21 13:25:26
Didn't work for my 1966 289 b8t had no problem returning it.
Egan West
2025-01-07 16:01:19
I was not getting a temp reading. I removed sensor. Ran under hot water and used multimeter to check resistance. The sensor was bad. I took old sensor out of old engine, did same test on old sensor, got a reading.
Recommended Products