Your cart is empty.
Your cart is empty.From the Manufacturer
Simpson Swan Secure S11A150RNBP wire weld Coil Roofing Nails are guaranteed to exceed T-304 stainless steel requirements. These nails offer the ultimate corrosion resistance for use in all high quality siding, roofing, decking and trim boards. Sturdy re-sealable tubes packaging reduce damage and waste. These nails will fit in Hitachi, Max, Makita, Bostitch and other similar 15-Degree roofing nailers.
Kael Blackwood
2025-07-07 18:01:22
The ringshank ribbing on these is at the tip end, the part that goes into the support wood, so they'll hold. Once the nail gun is dialed in for Hardi products nailing went well. The wired that hold the coil together are heavier gauge than what I was used to for roofing so loading was a bit ... not as easy. I would recommend these for putting up cement board siding.
D. Thomas
2025-06-11 18:51:40
I used 2-1/2 rolls of these putting up some hardiplank siding with a Milwaukee pneumatic coiled roofing nailer. Once you get the pressure right, the work great.
David M.
2025-04-10 13:38:37
This is my second order of these nails. Both packages were 1 cool of nails short. So I’m missing 120 nails. Only 4 coils of 120 nails arrived both times. Not happy
toby
2025-03-08 21:45:19
it doesn't fit my gun
Mark Tarabanovic
2025-02-06 16:21:57
A must for near the ocean. Everything else just rusts away
Juliann M.
2025-02-02 12:46:43
These work well in a Hitachi coil nailer for nailing aluminum shingles.
lee swope
2025-01-24 15:15:11
Tough as nails.
James Young
2024-11-22 11:26:15
Discription is wrong, there are only 360 nails (3 coils) not the 600 nails per the description. This almost doubles the cost per nail!
Recommended Products
