Your cart is empty.
Your cart is empty. Compatible with Chrysler and GM With Differentials:
9.25" Rear, '00 & older
9.25" Rear, '01-'10
8.5" Front - 28 Spline
8.5" Front - 30 Spline
8.5" Rear - 28 Spline
8.5" Rear - 30 Spline
8.6" Rear, '09 & up
8.6" Rear, '99-'08
Alan G.
2025-09-04 16:06:43
Less quess work
Joe D
2025-08-31 11:38:27
Used this on my chrysler 9.25 diff. It was so so so much easier than the crush sleeve. I measured the crush sleeve that came out and then stacked shims to be just a hair thicker. I was lucky enough to get it right on the first try.
Chris Kuskowski
2025-07-29 13:15:38
Wasn't sure if this would work based on another review but this worked on the zf rear Axle in my 14 ram 1500. The shims fit perfect, the sleeve was a little loose. I ended up centering it by wrapping the pinion stem with narrow tape and slid the sleeve over. 3 stars only because the sleeve should have an ID closer to the shim ID. They both have to fit over the same diameter shaft after all.
charles dethrow
2025-05-23 14:06:15
GREAT PRODUCT perfect solution , THE CRUSH SLEEVE IS A (B-S) DESIGN
Customer
2025-03-10 15:33:32
I installed just the "sleave" without any shims and I had an 1/8th inch of back and forth slop.. I pulled it out and used a crush sleave. I have a few other trucks that i need to regear so maybe it will work with 1 of them. It's a nice kit so I will give 2 stars instead of 1
Anthony Pillay
2025-03-07 10:26:46
Way too hard to get the shims right! I threw this away after hours of trying different combinations with shims and used a crush sleeve instead. Used a pipe on the ratchet and was done in 10 min
Walter
2025-03-05 12:52:55
Product was on time and worked like it was supposed to with plenty of shims left over. 4/5 stars only because shims were not marked
Tori
2024-12-19 17:17:13
The spacer would work but the shims were too small around go over the pinion shaft
Recommended Products
$535.00
$ 99 .00 $99.00
$140.42
$ 62 .99 $62.99