Your cart is empty.
Your cart is empty.Softride springs use only American steel and the individual leafs of each spring are shot-peened with hard steel pellets at very high velocities. This shot-peening compresses the surface of the steel thereby increasing the tensile strength of the spring. Without this shot-peening procedure, the maximum wheel travel and ride quality could not be achieved without sacrificing the life of the spring. Softride springs use bolt style spring clips, eliminating friction. Other spring designs use the cinch style bend clips which bend tightly over the spring leafs causing binding and friction. Skyjacker Softride springs taper over the entire length of the leaf creating more flex at the leaf ends. This tapering distributes loads more evenly over a greater area and reduces the tendency for one leaf to dig into the leaf above it.
Ryan Sampson
2025-04-07 11:32:00
The springs were labeled as they should have been and looked about the same. When installed one side sat more than 2 inches lower than the other and upon inspecting the springs, they did not appear to be matching. Dont know if its a seller or manufacturer issue but definitely dont buy from here.
Billy from the hills
2024-12-10 16:47:29
Too soft for a 1 ton truck. Beware you can't haul weight with these. Even with an extra leaf from skyjacker mine are unusable for my truck. They flattened out less than stock height.
Recommended Products
