Shopping Cart

Your cart is empty.

Your cart is empty.

Spectra Premium 93004 Vehicle HVAC Heater Core Replacement Compatible With Ford Excursion, F-250 Super Duty, F-350, F-350 Super Duty, F-450 Super Duty and F-550 Super Duty

Free shipping on orders over $29.99

$48.23

$ 23 .99 $23.99

In Stock
  • Fit Type: Vehicle Specific
  • Innovative engineering, manufacturing technology and quality control ensure that Spectra Premium heaters meet or exceed the performance of the original equipment heaters they replace
  • Designed for exact fit in the vehicle's original equipment heater casing
  • Fit type: Vehicle Specific


Innovative engineering, manufacturing technology and quality control ensure that Spectra Premium HVAC heater cores meet or exceed the performance of the original equipment they replace.


kosraedan
2025-08-21 18:40:23
It is an easy fix. This is seems a bit smaller than the OEM, but fits fine. After two weeks, no leaks. I recommend replacing the hose quick connects - the o-rings will be old and the existing units are a pain to disconnect. I recommend cutting the alum. tubing and pulling it through the firewall. I could change one again in half the time had I thought of that earlier.
Bryan M. Ray
2025-08-12 15:22:37
I knew I needed a new heater core in my '99 Ford Super Duty pickup truck. I watched a few YouTube videos to get a feel for exactly what would be involved in changing it out. The host in that video suggested this one through Amazon, as it was really well made and no more (or, even less) than what I could get locally. From what I've seen so far, I feel good about the purchase.
OmegaWolf72
2025-06-18 17:35:34
After replacing the water pump on my 02' Ford F350 7.3 diesel powerstroke, I wanted to also replace the heater core so they were both new. This was a Very Nice heater core replacement, fist exact as the OEM and comes with insulation wrapped on the sides, top and bottom at a fantastic price. I alsor replaced the factory clips with new ones cuz the original clips were showing signs of wear and wanted to take care of anything that could serve as a potential problem in the future related to the cooling system. Didn't have to take the dash out, just removed the glove box and a few things to allow for an easy install. Took only a few hours and the truck was up and running. Small Tip, Maybe consider parking on an incline to help burp out any air pockets that might get trapped in the motor or heater core cuz the heater core is a bit higher than the motor. I let my truck idle with the heater on high for about 35-40 minutes occasionally reving it up to 1700-2000 rpm for about 30 seconds at a time then slowly back down to idle. That seemed to help circulate enough pressure through the cooling system and heater core to get the air pockets to the highest point which would be the resevoir when parked on an incline. So Far So Good, 5 Stars and 2 Thumbs Up!
Wasatch
2025-06-16 21:20:40
I've purchased a few Spectra Premium products and I have yet to be disappointed. When I'm comparing different manufacturers parts, if Spectra Premium offers it- I'll buy it. They seem to be better designed than the majority of aftermarket parts in that they fit like an OEM part and the quality of materials and workmanship seem to be just as good as well, and at a fraction of the price.This particular heater core fit my vehicle perfectly (2002 Ford F-350). The original heater core has foam around it, which most aftermarket manufacturers expect you to re-use. Good luck with that! It's close to impossible to separate the original foam from the original heater core and keep it intact. Spectra Premium thoughtfully includes new foam, so the new core once installed should seal against the plenum properly. I appreciate that detail.
Vern
2025-05-07 20:43:06
Did not take me long to put it in. Fit like it was from the factory.
Paul From GA
2025-05-05 13:27:01
Seems to be well made, exactly to OEM specs and puts out some MAJOR heat! I am very happy with this in my wifes 2000 Ford Excursion with the 6.8L engine. Install was very easy considering some of the harder vehicles I have done in the past. Install took about 1 hour and is pretty straightforward. Remove the glove box and whala. There it is.
Soladaddy
2025-01-18 12:47:05
The good is the hoses line up and it fits correctly. The bad is it lasted 5 months and now my floorboard is covered in antifreeze. I get to do this job all over again.
John O
2024-12-10 11:40:16
Good part
Recommended Products