Your cart is empty.
Your cart is empty.Spectre's Carburetor Spacer was created for Holley, Edelbrock, Carter AFB carburetors. Featuring a 1 inch aluminum open spacer with tube precision die cast aluminum, this spacer was designed to increase power by raising air/fuel velocity. Gaskets and hardware are included ensuring optimum fit and function.
scott peters
2025-08-30 18:25:09
FIT GOOD AND ALL THE HARDWARE WAS IN THE KIT !!!!
C. Ruehlen
2025-07-30 11:17:23
Not sure what happened to the negative guys spacer but mine looks and seals just fine. This is on a Ford 408c that will be on a show car so I was concerned about the looks after reading some reviews. With the price I picked this up anyway to check it out for myself. Hardware was fine and everything threaded together as it should. Spacer was exact dimensions as advertised and perfect for my demon carb to trickflow intake. Gaskets were perfect match as well and everything looks great on my new motor. Will buy again and will recommend to you my amazon friends. P.s. pulling close to the same vacuum from spacer as the main on my demon carb, just in case you were wondering.
clyde
2025-07-29 13:55:17
nice spacer for the money perfect fit bolted right on had fitting for vacuum connection if needed plug it if ya don't its threaded would recommend to all
J. Glogowski
2025-07-23 18:34:50
It's exactly what I needed to add a vacuum port for my PCV issue. The downside was the finish on the product, it's pretty well hidden by the carburetor, but considering this was the $40 part and not less expensive $20 options I was expecting it to look more refined, after all, that's why I spent the extra $.
Sergio Azcuy
2025-06-20 14:49:44
Great value for the money
Siggy
2025-06-19 10:43:00
Great fit
Scott Sanford
2025-04-09 14:53:24
Exactly as described hole was tapped already too.
Just Al
2025-03-09 15:53:20
I ordered this purely to add a vacuum line to the o take manifold and it’s unusable as shipped. As others have said the bolt holes don’t line up. It will not fit on the intake or line up with the holes in the gaskets. Also the center hole is too small and out of alignment. This thing is trash. No other way to describe it.
JH
2025-03-08 15:39:29
Todo perfecto para un ford mustang 5.0 con carburador edelbrock y multiple ford motor sport de aluminio
Paolo Rotondo
2025-03-06 16:48:58
As advertised ðŸ‘
Tony melvin
2025-03-04 16:20:08
Fit perfect
IB_DUN
2025-02-03 17:02:24
It took an hour and 20 minutes to sand out the pits on the face of the casting (both sides). The studs are SAE, the nuts are metric size (not thread), the gaskets almost fit. Had it not been for time constraints, I would have ordered differently, as it turns out, I had to source locally to get a spacer that worked (didn't leak). Unless you have a machine shop, you're not going to be happy with this.
Customer
2024-12-23 13:09:09
Spacer was far from flat.....had a huge blemish / bubble in it from the casting process. Had to put on a large belt sander to get it flat or there never would have been proper gasket crush. Also.....gaskets supplied weren't even close to the plenum opening, had to trim.
Recommended Products
