Your cart is empty.
Your cart is empty.The Square D X Series 3 A 500W Single Pole Occupancy/Humidity Sensor Light & Fan Control with back wires, is an occupancy sensor, light switch, and fan control in a single, easy-to-clean matte finish. Automate lights to ON/OFF based on occupancy and available natural light to make saving energy easy. Enable manual control of the fan or lights at any time via two independent push buttons. Adjust timing for fans and lights in increments of 10, 20, or 30 minutes. Set relative humidity levels between 30 - 85%. Complete the look with one of the Square D X Series cover plates (not provided) that easily snaps into place for a modern, flush-facing finish to your walls. Enjoy a consistent look in your room or home with the full line of Square D X Series switches, dimmers, sensors, and receptacles.
Bobby Mac
August 10, 2025
In a bathroom where CA Title 24 requires an occupancy sensor and humidistat, this manages Code compliance if you don't have the space for additional devices.
Matt R.
June 30, 2025
Instructions little confusing about programming. But figured it out when I went to manufactures website. Nice programming videos.
Bcmel
June 7, 2025
The light goes off manually or after 3 min which is great. The fan only goes off manually or based on a humidity level or as I recall 20 minutes. So you lose a lot of conditioned air in the house if you let this go off on its' own. I wish I could set a much higher humidity so that it would go off sooner on its' own.
Jorge peregrino
June 1, 2025
My shower is a 8x7ft area, and some times the humidity detection doesn't work, and I have to turn it on manually, not a big deal, but this device supposed to be automatic, the humidity sensor is programed at 'high sensitivity' but sometimes work and sometimes not
brandon
April 6, 2025
This is not smart home compatible. Does not connect to any wifi as stated and I waited to long to install
N. Jagielo
March 5, 2025
Product worked as advertised for a few months, time to return window has closed and the product now only controls light by pressing switch. Fan cycles on and off at random intervals.
Abstract Error
January 20, 2025
The renderings show a red ground wire and green hot wires. This is either a really sad mistake in the rendering that made it out the door without even a basic review or SquareD is actually selling switches with wiring incompatible with the US's National Electric Code as well as numerous industry standards meaning they haven't actually passed NRTL (UL, ETL, etc.) approval.
Recommended Products
$24.99
$ 12 .99 $12.99