Your cart is empty.
Your cart is empty.Standard Motor Products PSS30 P/S Pressure Switch Assorted , One Size
K J
2025-08-06 15:50:58
I believe this is a quality product. It fit, it does not leak, and I could install it myself.
JD Larrick
2025-08-02 17:53:40
Much cheaper than OE part, similar quality. Works fine. Wrench flat is larger than OE. Used small vice grips to install, as I don't have a wrench thin enough to tighten the sensor without binding against the power steering line.
RON LUPORI
2025-07-14 14:07:55
NO EASY WAY TO REPLACE THIS SENSOR.BEST FROM UNDER THE VAN,THRU THE WHEEL WELL.
cl206
2025-07-08 17:11:10
I am really liking intermotor parts! Never an issue and this part fit and worked great for the 2000 3.0L accord v6!
K. Hirano
2025-06-16 15:34:55
Used UV dye & light to find slow Power Steering Fluid leak from in/around the pressure switch. Used a 17mm Bicycle tool wrench and thin crescent wrench to break switch from high pressure hose (careful not to bend/kink hose). Quickly swap out old for new so you don't make a mess and just snug it down (8.7lb-ft per Honda Service Manual). No leaks under UV light after a quick test drive. Good aftermarket P/S Pressure Switch from Standard Motor Products as far as I can tell.
Roca
2025-05-09 14:20:59
Muy bueno excelente
Madison
2025-04-13 12:07:26
This product was in spec. I bought an aftermarket high pressure line which required a larger o-ring to make a good seal.
Bcrichster
2025-01-28 18:33:51
Finally installed on D16Y8, fits perfectly and works great so far
Recommended Products
