Your cart is empty.
Your cart is empty.Mount your server or networking equipment to the wall, using this adjustable 12U open frame rack Mount your server or networking equipment to the wall, using this adjustable 12U open frame rack - Easy installation with mounting points positioned 12 and 16 in. apart to match standard wall studs - Flat-packed for easy and cost-effective shipping - Network rack / server rack / Computer rack / Equipment rack / open frame rack / 12U server rack / 12U wall mount rack / wall mounted rack / small server rack / 12U rack. Accommodate larger devices with adjustable frame. Free up space by mounting your equipment on the wall. Easy installation with mounting holes spaced 12 and 16 in. apart to match standard wall studs. Comes in a flat-pack making it easy to transport. Open frame provides passive cooling for equipment.
Joey Paul
2025-08-31 13:57:45
The absolute best wall mount rack shelf solution on the market! High quality, well engineered, easy to install. Worth every penny!
NKC, MO
2025-08-23 16:23:59
Needed additional space in network rack - selected the 8U depth adjustable rack. This thing is solidly built, very sturdy and easily adjusts the dept to allow for a variety of most common devices. The open top, sides and bottom allow for easy cable management, access and fan-less ventilation.My rack arrives pre-assembled, with only needing to remove the 16 bolts to extend the depth and inset the cage nuts.Only considerations / slight cons: My rack did not have markings for the U positions as others have shown. Not an issue as just did quick marks with marker to ease installation. The cage nuts that came with it were not the best and had several occasions of the cage nut popping out while installing component. Also didn't notice cage nuts and bolts are M5 rather than M6 (which is a bit more common) until was missing 3 bolts and attempted to use cage bolts I already had, after lots of cussing discovered my old rack used all M6 cage nuts and bolts. But minor considerations for a very reasonably priced and sturdy wall mount rack.Be sure use solid 1/4" lag crews (not included) into studs, or if stud alignment is off (like mine was) a good piece of plywood backer which is attached to the studs.
J. Allen
2025-08-17 12:01:55
A great rack! Mounted directly to the studs and it works great. Thing is super heavy duty! Easy to setup. I would highly recommend.
J S
2025-07-30 10:03:58
This thing is a tank! At first I was disappointed it doesn't have any vertical rails in the rear, but if assembled properly, you really don't need them. Assembly isn't difficult, but it took longer than I'd have expected. Fortunately, I got the exact depth needed.I do low-voltage work on the side, something I've done for more than a decade. I've installed dozens of different wall-mount cabinets and racks, from 2U racks up to 26U cabinets. This was far easier to assemble and more logical than most. It gives depth flexibility, everything you really need comes in the bags. I had enough capture nuts and hardware to mount my equipment and shelves.This is probably more than what your average person needs, but it fits my QNAP NAS, Unifi switches and UCK, patch panel, CCTV DVR, and Fortigate nicely. Initially I thought I would've liked something height-adjustable, but this was the perfect height for me. Very sturdy. Very heavy. Very well-finished. Exceptional bang for the buck. Highly recommend this product!
Andrew B
2025-07-28 21:04:10
I've used the 18U version of this rack for three IT closet builds for small businesses and it's been great. The rack itself is very sturdy and has all the wall mounting points you'll need. No complaints.
James Sumners
2025-06-10 13:23:48
Fantastic rack. Very easy to extend and very sturdy. I'm knocking off 1 star because it doesn't come with any recommendations for mounting hardware; it simply says "use appropriate hardware." Their excuse is "Unfortunately with any of our wall mount racks we are not able to provide specific bolts as each customer setup can vary." I think that is quite weak. It is certainly possible to provide some recommendations based upon the maximum capacity of the rack. At the _very least_ they could provide a list of bolt sizes that fit the mounting holes.For others with the same problem, here's what I did:1. 4x 1/4x2"2. 12x 1/4" washers3. 8x 1/4" nuts4. 4x 1/4x1/2" nylon spacers5. Sheet of 66"x36" 1/4" plywood6. Install bolts from the back of the plywood with a washer on each side. Affix bolt with 1 nut and some loctite7. Mount plywood to wall with some general 2" construction screws8. Put nylon spacers on the bolts9. Affixed rack to the bolts with remaining washers and nutsIt's not going to come down.
Brad B.
2025-05-13 14:16:52
I rate very few reviews, but occasionally there are gems in life that should be praised. I have been through MANY racks in my life dating back to the early 90s. This is possibly the best 2 post wall mount for a prosumer ever made, but certainly for the money. Everything about the construction is very heavy from the rack itself, its fit and finish, all the way to the provided nut and bolts (you’ll opt for them over any provided by your components). If there is a single gripe, it’s that it is heavy. So be prepared to have a very solid foundation to hang in on the wall from. That said, I’ll take thick and sturdy any day.Possibly it’s greatest feature is the 12-20 inch variable depth. I have twice adjusted the depth as I shuffle components in and out of the rack and the stability for adjustment (loaded while hanging) is borderline legendary. I would normally be puckered up pretty tight if I was trying that with any other variations I have touched.Ignore the negative reviews. These folks are clueless muppets that did something silly. I’ll keep coming back to this well when I have a need.
Scott Jackson
2025-05-04 13:26:44
Built like a tank. Well engineered! Versatile. Affordable. It’s perfect. I have a lot of equipment mounted in it and feel very comfortable with the quality and strength.
khx73
2025-04-19 15:03:27
Very well built and sturdy even at extended depth adjustment. Full of equipment including a 1300va UPS on the bottom. Rock solid. Generous amount of quality hardware included.
Arneby
2025-04-15 14:44:44
My goto rack model for home use in a cupboard. Flexible depth is very useful and the construction is very sturdy.
chriskulap
2025-03-20 11:54:55
Ich wollte endlich einmal das Chaos meiner Netztwerkgeräte beseitigen. Da ich mich nicht so gut auskenne habe ich mich von den Rezensionen leiten lassen und das ist auch der Grund, warum ich diese hier schreibe. Das Rack ist wirklich sehr stabil. Ich nutze es als Regal und habe die obere Abdeckung weggelassen. Das stellt aber bzgl. der Stabilität überhaupt kein Problem dar. Die Tatsache, dass die Tiefe einstellbar ist, ist ebenfalls super, ich habe nicht so viel Platz unter der Schreibtischarbeitsplatte. Ich habe überhaupt keine Kritikpunkte, das Geld ist definitiv gut angelegt!
AJ
2025-02-23 10:55:46
This rack was perfect for upgrading a network install which had been crammed into a cupboard far too shallow to take a decent sized cabinet. This rack wastes zero space and having the sides open means easy access; I was afraid it might be a bit wobbly given the lack of bracing but needn't have worried as this is a very sturdy (and very well finished) rack indeed.No sharp edges anywhere; easy to assemble; decent sized holes for wall mounting; adjustable to the precise depth required - very impressed.
ãŸã˜
2025-02-08 12:43:05
ã“ã‚Œãらã„コンパクトãªã‚‚ã®ã§ã‚‚ã‚‚ã†äº‹è¶³ã‚Šã¾ã™ã。
Recommended Products
