Your cart is empty.
Your cart is empty. Supco SHP450250 High Pressure Switch
High pressure SPST open on pressure rise
Temperatures: Ambient 20°F to 176°F (-30°C to 80°C). Fluid 60°F to 250°F (-50°C to 120°C)
Related Voltage: 50/60 Hz, 24/120/240 Volts (6 RLA, 36 LRA)
Life at rated load: 100,000 cycles
1/4" SAE female flare fitting with valve core depressor
Snap acting stainless steel hermetically sealed sensor (SHP, SLP, and SFC)
Small size and lightweight for direct mounting
Excellent set point repeatability/stability
Pressure range: 0 to 650 PSI
Burst pressure: 5000 PSI
Tolerance: ±15 PSI
Close PSI: 250
Open PSI: 450
Rodolfo Gonzalez
2025-01-29 12:25:16
Most residential units don't have individual shutoffs, which would allow you to pump down into the condenser and lock it in so you can replace a low or high side pressure switch. High side switches fail when the condenser fan motor goes out and your unit cycles due to the high pressure that bad fan causes. You can do this yourself: I used this with a tee on the high side with some refrigerant-friendly thread lock. All you do is screw this switch onto the new tee and then onto the high-side port. Move the two wires off the old switch onto this new switch, and make sure you have that fan replaced by a professional! A new fan on Amazon is usually $170. Have it installed and you just saved almost $2000. You're welcome!
djtrob
2024-12-28 13:26:59
Does what it is supposed to does not leak.
Recommended Products
