Your cart is empty.
Your cart is empty.Product Description
Features:
- Designed for dropping in a 2003-Up Crown Vic front suspension into your F100 pickup.
- Swap bracket kits are cut out of 3/16" mild steel, and have 1" .120 wall tube for the 4 main mounting bolts to go through as well as the alignment pin hole on the bottom tab.
- Can be fully welded based on your liking, can come bent and tacked during installation.
- Lower control arm mounts are included.
- Bulit to strict quality control.
Installation Instruction:
- Simply remove the front suspension and crossmembers.
- Measuring out and drill your alignment pin holes through the bottom of the frame.
- After that Jack up the new crown vic suspension and then make the cuts on the top of the frame and slide these brackets in and bolt it together.
- After that you then fully weld seams up and weld the bracket to the frame.
brian
2025-09-02 18:03:44
This item 1/3 the price of similar models. Looks to be cut from same steel and plasma table. Others cost 3x the price. Buy this. Save money!!!!
Jeremy Harris
2025-08-13 13:33:00
Very solid material and the craftsmanship is great.
Ryan Baird
2025-06-26 21:09:53
Came super fast exactly as pictured fit perfect.
william R.
2025-06-15 12:01:54
The product was a good piece , but a simple instruction sheet would have put it at 5 , I have been doing cars for 30 + years , the top edge that is bent ove can go inside or outside , we got it in and driving just that one ?
Raul C.
2025-05-20 16:22:08
Good quality product.
Laci Conner
2025-03-28 11:17:22
Great quality.
Doug Denton
2025-02-15 20:58:22
These are a great way to insure a strong and clean install. Would buy again in a heartbeat.
MeanGreen
2025-01-30 19:32:36
Showed up rusty. I understand its metal, however most companies put a coating of some sort on metal. Plus these feel like a black powder on it. Not impressed 😕 .
Recommended Products
$37.80
$ 16 .99 $16.99