Your cart is empty.
Your cart is empty.Spring-loaded ball keeps stamps attached to the handle when you lift it off your project. For 1/2" (1.3 cm) , 3/4" (1.9 cm) & 1" (2.5 cm) alphabet and number stamps. Also for 2-D & 3-D Stamps.
Michael Triska
2025-07-09 17:38:52
Well made piece of Steel
Wes from Yorktown
2025-07-08 18:11:17
it's a stamp handle. You put it in the back of a stamp and whack it with a mallet
Brandi Pearl
2025-07-04 17:39:43
It works really good with the leather stamps and is a good value. It does wobble a bit with some of the stamps, but it is still sturdy and works well if held securely. I would definitely purchase again - Five stars from me :)
Logan Crosier
2025-06-28 14:37:39
It's nicely made, but I really wish it was fit to a tighter tolerance so the stamp didn't wiggle so much.
JP Stewart
2025-06-17 10:25:24
I purchased a set of Tandy leather stamps and realized there were left-hand and right-hand stamps in the set. To switch between the two, it was necessary to switch stamps on the handle. Purchased a second handle (this one) so I wouldn't have to switch, just pick up the next stamp.
Howie F.
2025-06-11 14:57:23
didnt realize that a few of my leather stamps didnt come with a handle so I ordered this and it fits them all. I wish they 'd sell them together or at least recomend the handle when looking at stamps.
Tony
2025-06-05 16:47:59
So far it seems to be working. Used a couple of times with no problems.
Michael
2025-06-04 16:49:38
No snapping power
AndyS
2025-03-29 14:25:34
Having purchased some larger leather stamps I realised I needed one of these. This one is well made and solid. Does the job to a T
Jakub
2025-01-12 12:30:25
Nach einigen Einsätzen fällt das Werkzeug vom Stanzgriff. Ich habe dies meiner Freundin als Geschenk gegeben. Aber sie kann es nicht mehr richtig benutzen. Sie kann es immer noch positionieren und drücken, aber der Stempelgriff sollte die Werkzeuge auch nach wenigen Einsätzen halten.
Chico
2024-12-02 15:45:06
good
Recommended Products
$39.99
$ 20 .99 $20.99