Your cart is empty.
Your cart is empty.Paul F.
2025-05-23 15:23:51
works well Its only 1 not 3
Diego Romero
2025-03-13 16:32:04
Works great! Pre-heated the nozzle to 230*, pushed this through and was ready to print in less than five minutes.
Jonathan O.
2025-01-19 16:14:46
Broke the first time using it. Lodged a small piece of the tip in the extruder. Having to take my 3D printer apart to hopefully remove it. If not then I'll have to order a new extruder. By the way i have a K1C. So here's hoping I don't have to spend more money on replacement parts.
isis Padilla
2025-01-05 14:19:37
the tool is good for the job well made. my mistake was to think that because the picture shows 3 I wold receive 3 of them. but in description says one.
beepboop
2024-12-29 18:19:33
Went with this since I had a clogged nozzle on my mk3+. Before use make sure to turn off your filament sensor and loosen/remove the idler screw.Once done preheat and slowly work the clog down so it comes out the nozzle. Clean the nozzle frequently while pushing down and repeat if you need it.
Tristyn
2024-12-13 17:22:40
First off, this tool works GREAT! I had been struggling with a clog for about a week. Normally I would just take about the hot end, replace the throat and nozzle and off we go. The new K1 Max is a little more labor intensive. I saw this tool and it was quicker than waiting for a new nozzle so I gave it a try. Within minutes, the AcrossXD had cleared out a large glob and the printer was working perfectly again. Now for the but. The handle is sturdy solid plastic with a rubber grip, a nice strong chuck holds the needle in place. The trouble is the connection between the handle and the chuck. It's very unreliable and the chuck falls out often. I can see myself forgetting to hold the chuck while tipping it to insert it into the hot end and having it fall off and either piercing my foot or putting a nice hole in the build plate. Really needs to be magnetized or something for a better connection.
Kenny G
2024-12-11 12:56:27
According to the description this item is supposed to come with 5 nozzle cleaners and a blade. All I got was the throat cleaner. There were no nozzle cleaners and no blade. As an update, after finding out I got an incomplete set, the fine people at "ACROSSXD" sent me a complete set, one that contained both the needles and razor blade.
Mark
2024-11-30 15:35:51
Works great pushing out plug
Recommended Products
