ShoppingForThePerfect....
2025-08-25 12:30:02
This was perfect for the use I intended, to cover the holes in my oven/range to keep mice from accessing it and destroying the $600 main board. I put in over all the holes in the back, the gaps near my baseboard, and even spray painted it black to match and used it to cover the vent holes on the top of the range. Looks great and you can't even tell it wasn't done that way by the manufacturer. (I wish it had been!). Duct tape or any strong tape holds it on securely, as well as small screws or rivets. Edges can be sharp, be careful.
Mark Zemke
2025-07-17 15:56:56
I got tired of having to go to head shops and settle for screens that are waaaaaaay tooooooo fine for 420 smoking through a pipe ... I just couldn't find the right size of mesh ... THIS is it = stainless steel screen in size 30 mesh ... with this package of flat screen, the cut-to-size screens end up costing a couple of cents each, and are strong, long-lasting, easy to cut with good scissors or sheet metal snips, and perfect for your favorite 420 indulgence ...
Brakemanbob
2025-07-11 18:00:04
I used one of these sheets on a project I was working on and it worked great.
Darren H
2025-06-14 14:57:56
Wanted this to cover the insides of some stainless steel ventilation covers for an outside gas grill. The covers are a standard 14 or 15 inch width, but these sheets are only 12" wide. So I'm going to have to overlap two sheets to cover one vent and somehow seal up the join to stop the "wee beasties" getting through the gap.Otherwise A1 - sturdy mesh, small holes.
Matt
2025-04-21 11:35:48
I used this in a vent to keep flying insects out.
Jeremy
2025-04-05 18:26:26
Bought to replace pickup screen on a Farmall oil pump, seems to fit the bill and be higher quality than the screen it's replacing
SonofJay
2025-02-19 09:43:24
So it all started one night with a spider we believe came out of our floor vent register. My Wife and I immediately looked for solutions. This was perfect! They came in sheet, I literally folded the sheets in half the long way and with pair of house scissors cut down the folded seam. I had to make one more cut across the top to fit the vent and voila it was ready.Depending on the type of vent register you have you my need to make a few more cuts to fit around the clips but it was pretty easy to figure out and every last vent in our house (14) were done with 3 packs with sheets to spare .My contractor saw them and thought the idea was ingenious and asked me what I did. Thanks to my Wife for finding these.
Iwona T
2025-02-10 20:29:41
Works,but is better working with thin wall Walmart style cookware!
Jerry
2024-11-30 17:03:27
the mess did the job. easy to cut and pliable