Your cart is empty.
Your cart is empty. Titan 51830 Dodge Spindle Nut Socket
- 1/2-inch drive
- SAE size: 1-11/16"
- Metric size: 43mm
- Heavy duty steel CR-MO construction
This socket is designed for use on 1994 through newer Dodge 1/2 ton 4x4 pickups with Dana 44 front axle or Dana 60 axle with vacuum disconnect front axle
kc
2025-09-04 17:33:22
Well made
R. Bolinger
2025-07-23 11:44:25
Worked great on front hub of 2006 Dodge Ram 2500 4WD
Nicholas Lynn
2025-07-09 14:15:39
Used this to remove the castle nut on one of the front hub assemblies of my 2003 dodge ram 2500. It was obvious that someone else bought it, used it for the one or two nuts they needed to loosen and tighten then returned it, but hey, it wasn't broken or worn. I'll keep it myself just because I'd rather not fight to find another later if I need to replace the other hub.
Nathan Sullivan
2025-07-08 15:27:46
Tough tool , tourqued castle nut to 240 ftlbs and didn't make a scratch on the tool.
HazeyFla
2025-05-08 17:47:35
Had a stubborn rounded bumper bolt that had been on the truck for almost 30 years and these sockets spun it off like nobody's business.
Josh
2025-02-10 14:13:59
Really good made socket, i broke the breaker bar drive and the socket is perfectly fine. Ended up using a strong impact to get the nt off. Dodge 2500 2006 model 5.9 cummings motor
ERD
2024-12-12 14:14:44
Worked great thanks...
Arlan bates
2024-11-26 19:31:12
Supposed to fit ram 1500,to big.
Joaquin Gomez
2024-11-23 16:43:17
Lo compré para quitar la tuerca de las lavadoras GE pero al ser de 1/2" choca con la flecha de la transmisión, debà comprar el de 3/4", ahora tendré que perforarlo con una broca más grande para que logre bajar el dado por completo y posteriormente soldarlo a un tubo para facilitar la extracción.
Recommended Products
$38.92
$ 16 .99 $16.99
$209.99
$ 82 .99 $82.99