Your cart is empty.
Your cart is empty.This product is NOT legal for installation on vehicles required to meet CARB standards and/or registered in California and other states following CARB standards, including NY and ME.
Timothy
2025-08-01 12:04:12
The adapter came very quick and was in great condition. It bolted up just like it was supposed to. Would recommend again and again
John Baxter
2025-06-29 11:28:06
Product looks good and sturdy. It is fairly thick and pretty heavy, should work well. I will update once I actually install it. I have a throttle body Spacer but as thick as this is I don't think I will use it with this.
alicat
2025-06-19 11:04:48
I did not notice any warpage that others have reported, fit and finish looks good
Jason Smith
2025-06-02 17:07:40
Decently made product by t failed to seal properly on my spread bore plenum. Had to get adapter plate to make proper seal below TBI adapter
K. A.
2025-04-26 11:24:12
This product could be awesome however it was not designed very well and I have no idea how this got through product testing .. I expect they tried a Square Bore intake and said it was all good.If you use the studs they supply you will end up damaging your intake if you have an EdelbrookThis bolted up fine but upon tightening with a 1/4 inch drive rachet it stud screw directly into edge of the intake, if this was tested and mocked up better if it was move 3/8 of an inch towards the front it would be perfect .."This Bolt on part" will end up costing me over $300 .. Be careful
Lawrence Raymond
2025-03-23 16:07:37
Good
James
2025-02-21 18:34:33
it fit great just as needed, i used it with a 305 motor that i wanted to run tbi !
Jacob
2025-01-06 10:51:26
Adapter will get the job done but isnt a perfect swap over the adapter puts the tbi 1 inch back that could possibly lean the front cylinders out. Plus the clearance of the vacuum port and the TBI fuel lines along with coil could be an issue.
Recommended Products
$38.95
$ 16 .99 $16.99