Your cart is empty.
Your cart is empty.B2
2025-08-11 16:45:12
I have a very clean used Well Tempered Turntable. The cartridge connectors were shot and wires too short to be used in their original configuration. Unable to lengthen the wires easily thru the tonearm (packing and sand), I bought these, cut, tined and surgically spliced them in with silver solder, used a small bit of RTV to insulate from each other and I am back to full function.
genchic
2025-07-27 13:32:12
At firs I thought these leads wouldn't work out due to their length. Yes, they are a little longer than oreginal Technics/Audio-technica leads, however, after I managed to tuck them into the headshell, and put the cartridge on the turntable and started the record, the difference in sound was way better than with the original wires. The connectors fit right in, not too tight, not too loose. I wish they were 1 3/4 inch long instead of 2 inches, but, as I said, they are manageable and deserve 5 stars.
Ted Murphy
2025-07-08 14:53:52
The Yamaha pins are female as are both ends of the set. Good luck finding a set specific to this headshell. Was able to gently open one end slightly with a dental pick enough (Harbor Freight sells) to get them to fit over the terminals without incident. Should work flawlessly on P-mount and similar shells.
EyeDontKnow
2025-07-05 14:53:17
Works, but barely fits. Wires too short. Wires too thick and not flexible enough. Wire connections too bulky.These cartridge connectors should be flexible and lightweight. These are not.
RichardC
2025-06-23 18:00:19
As much as I wanted to like these wires, I can only give one star. They are very well-made with heavy gauge wires. The cons? The terminal pins are way too loose to fit the cartridge and fall right off. They ought to be "plug-and-play" so it's not my job to crimp them to fit. Also, they are much longer than all the other wires I've used over the years. It would be very difficult to stuff all that material between cartridge and headshell even if the pins fit.
Yacope
2025-05-21 17:12:27
As described, works well with the record player head I have.
Hoosier_Dad
2025-02-22 18:21:20
Had to crimp them slightly to stay on
Robert W.
2025-01-28 09:37:44
Very nice headshell wires. Cost was very reasonable. Excellent response time.
Recommended Products