Your cart is empty.
Your cart is empty.Power Rack and Pinion Kit1965-1966 Ford Mustang with Small BlockThread: 9/16"-18Spline: 17mm DDIncludes Outer Tie Rod Ends, Pump & Line Kit, Steering Shaft Kit, Bracket & Mounting Hardware Amount of Travel: 6" Turns Lock to Lock: 2.5-2.75 Turns Pressure Port Size: 18mm - 6AN Return Port Size: 16mm - 6AN
James Nummerdor
2025-05-25 11:03:37
Have not made it fit yet. Angle is too sharp going into the rack. Company is real helpful so far. Sent it back and have not heard back as yet
Philip L Ball
2025-05-20 12:34:21
I have not fitted it yet but wanted to answer some potential questions. As far as I can tell this is the same as the kit offered on the Unisteer website and at other distributors.The shipping info is obviously wrong it comes in a large box and weighs a lot - my guess is around 40-50lbs. Comes with the pump, lines, rack, tie rods ends (presumably for stock V8 spindles not Granada - but I havn't tried yet)I asked a Unisteer sales tech and he didn't know why this was on Amazon or how it got here (or why it was cheaper) but as far as I can tell this is the real deal.
giggle
2025-02-25 18:37:43
Not a direct fit. Plus, kit shows tie rod ends. However, kit did not include them..
Ricko
2025-01-16 12:20:27
easy install,frt. end feels real tight and quick now,good improvement over stock manual steering would buy again.
Customer
2024-12-05 11:30:00
Listing states fits 65-66 Mustangs. It actually is for 67-70 Mustangs.
Recommended Products
$118.04
$ 56 .99 $56.99