Your cart is empty.
Your cart is empty. M12 CCTV Camera S Mount Lens Holder 20mm Spacing
xsk8rat
August 10, 2025
The bottom is completely flat. So passing even a flat cable from the outside will hold up that side. Some holders have small stand-offs (or cut outs) for this purpose. This does not have that feature.The spacing of the mounting holes is slightly smaller than the existing holes on my Arducam. It was a guess for me that this would work as it was hard to accurately measure the holes. But it worked!!!Nice clean casting. Threads for the lens are well formed. Maybe a little bit loose if you need to adjust the focus using them.
Hello Doggy
July 23, 2025
works
Justin Goff
July 6, 2025
They win by default. No other seller seems to have these listed, but here they are. Doesn't exactly line up with raspberry pi camera, but then again I didn't measure and was easy enough to modify the camera. Works of me
Customer
June 14, 2025
Unfortunately, they're exactly as pictured, specifically they'll hold a M12 lens but don't include the set screw!
Rick
June 11, 2025
No problems.
A Hernandez
May 14, 2025
Wish these worked on the raspberry pi cameras. But it is as advertised.
Gabriel Constantinescu
May 9, 2025
The housing is too long. The focal length is too long. I can't use wide angle lenses because of this.
MarkS
April 29, 2025
They are fine for the price.Dont forget screws - The holes are not threaded - so either M2 self tapers or 10-12mm long m2 bolts
マã‚
April 25, 2025
VL-522Lã®äº¤æ›ãƒ¬ãƒ³ã‚ºã«ä½¿ç”¨å¯èƒ½ã§ã—ãŸã€‚ペーパーã§4㎜薄ãã—ã¾ã—ãŸãŒã€ãã®ã¾ã¾ã§ã‚‚使ãˆã‚‹ã‹ã‚‚ã—ã‚Œã¾ã›ã‚“。１個ã—ã‹ä½¿ã‚ãªã„ã®ã§å…¥æ•°ãŒå°‘ãªãã¦ã‚‚良ã„ã¨æ€ã„ã¾ã™ã€‚
J Burns
April 13, 2025
Last minute ditch attempt to get a project working, fits all M12 threaded lenses. Minor flanges from plastic, but easily shaved off with cutting knife.
kai
December 21, 2024
ç¾çŠ¶ä»˜ã„ã¦ã„ã‚‹ã‚‚ã®ã«åˆã‚ã›ãŸåŠ å·¥ãŒå¿…è¦ã§ã™ã€‚ピントもå•é¡Œãªã復活ã—ã¾ã—ãŸã€‚
Recommended Products
