Your cart is empty.
Your cart is empty. Description:
-Clip on ferrite bead cable can be used on all kinds of wire cords such as: Power Cord, Audio Cables, Data Cable, USB Cables.
-It helps improving the electromagnetic field and signal quality around the cable, avoiding outside interference.
-It won't cause distortion of the transmitted signal and won't affect your audio, video and picture quality.
Note:
Please install them in place near the interference source. (Near the import and export of shielding case as much as possible.) If a cable has equipment that needs to be protected on both sides, install one at each end.
TIPS: There is a tolerance of 0.8mm and it is recommended for use in cables smaller than the maximum diameter range.
Specification:
Model: Φ5mm
Color: Black
Fit Cord Diameter: 3.5mm-5mm (0.14"-0.20")
Size: 13 x 25mm (0.51" x 0.98") (D*L)
Application: Driving Recorder DVR, Audio Cable, Mouse Keyboard Cable, USB Cable, Headset Cable, RS232 Serial Port Cable, etc.
Package Content:
10 x RFI EMI Filters
TIPS: There is a tolerance of 0.8mm and it is recommended for use in cables smaller than the maximum diameter range.
Cuda70
2025-07-14 17:59:47
Easy to use Works nice
Tyler G
2025-07-10 12:08:31
I have some wall mounted speakers connected via unshielded cabling run through the wall. Replacing the cable wasn’t really feasible so I bought these hoping it might help.I was pleasantly surprised that these effectively eliminated all the hum and saved my speaker setup!This isn’t going to solve all problems with perceived hum, but in my case it was exactly what I needed to effectively shield my speakers from the electromagnetic interference from adjacent electrical cabling.
Matt from New York
2025-06-29 13:24:01
I tried these on cat5e cables, and just a bit too small. The little prongs that stick out the ferrites appear to be the problem. I think the round part diameter is sufficient. These are supposed to be 5mm and I had measured my ethernet cable diameter at about 4.7mm, so they should have fit.These are small measurement amounts, so I'm hesitant to fault the product too much...otherwise they seem fine and I'll keep them around for smaller cables that might need them.
Ken K.
2025-05-16 16:15:13
Does a decent job of noise suppression and if one doesn't do it a one or two more.
Spammy Hagar
2025-03-19 19:01:59
I was hoping to use these on ~9mm cat7 cable to choke some PoE noise that my cameras spew from around 10-20MHz.3 of these in a row on 9mm cable, right at the camera basically did nothing for my problem (since that's essentially just 3 turns, and would be around 240 ohms @ 25MHz, according to their specs), whereas 8 turns on a big ft240-43 donut works great. I just can't fit that big FT240 toroid back up through the cable hole in my situation.I was trying not to have to go winding big chokes in the attic, but I guess that's my next option.These are probably much more effective on smaller wire that you can achieve a few turns with, but I cannot attest to that.For the price, they were worth a try, and I'm sure I'll find something to use them on.
3.5-5 mm unit
2025-03-14 14:00:37
Looks good
russell Washburn
2025-02-26 15:19:20
Easy to install
GM
2025-02-14 12:12:06
Didn’t help at all
Recommended Products
