Your cart is empty.
Your cart is empty.Shower Doors By Design
2025-06-15 14:27:49
GREAT PRICING, GREAT BITS
HVG
2025-06-01 11:15:34
I have my own business installing custom glass shower doors and go through a ton of tile drill bits. I like these, the price is definitely right.The 5mm are the right size for a 3/16" hole. You'll want to keep a little cup of water handy and stop to quench the bit in water about every 6-7 seconds, otherwise the weld can heat up too much and you'll loose the tip inside the tile. It goes through ceramic like butter but natural stone, you'll want to drill in a slight circular rocking motion or use your hammer drill setting to speed up the drilling process.Pro tip: save your dull bits. If you take a yellow handled tin snips and snip off about 3/16" of the tip of this bit, then it'll turn your bit into a tile analihator. Start your hole with a normal tile bit then switch over to your modded tip and it'll plow through hard tile like nothing.
Recommended Products
