Your cart is empty.
Your cart is empty. Specification:
Material : Spring Steel (60Si2Mn)
Finish : Chemical Blackening
Material Thickness : 1mm
Material Width : 10mm
Spring OD : 56mm
Expand Length : 1540mm/60.6inch
Inner Mounting Type : Hook
Outer Mounting Type : Hook
Package Content :
2 x Drill Press Spring
Description:
1.The drill press quill return spring is good replacement for many existing quill spring drill presses, this is the chrome housed spring that returns the quill to the top after you have completed drilling.Used to all kinds of vacuum cleaner coil spring, volume tube coil spring, safe coil spring and so on.
2.Chemical Blackening, the performance of the product form oxide film, isolate the air, prevent rust.
3.Pay attention to safe when installing springs. Do not loosen the wire of fixed springs! When installing, install the spring with a fixed wire directly into the spring , and the wire will slide out.
Lucy
May 2, 2025
I couldn't find a direct replacement spring for the old Guardian drill press so searched this spring out as a close fit (by size comparison) substitute. It fits well and works well. Satisfied with this choice and the fact that it comes as a 2-pack so that I'll have a spare.
SecureType
February 6, 2025
Works fine, 10mm wide is better than 8mm. The bend at the inner diameter of the coil was not long enough to stay in the slot of the axle, but I went past it and jammed the curved beginning of the into the slot, leaving the bent end to function as a "hook" so it cannot pull out. Functions just fine in a 1980 Duracraft DP-514 bench press. There are (2) spring coils in this pack, so I have a backup, even though the machine will continue to work long afted I am gone. Would buy again, how can I go wrong?
keyur kothari
November 26, 2024
material quality was good with proper hardness. just check dimension with spare spring before purchase.
Recommended Products
