Your cart is empty.
Your cart is empty. Morse Taper Drift for Morse Taper MT1 and MT2 Lathe Drill Sleeves Carbon Steel
Feature:
High hardness, high toughness
After quenched, not easy to broken
Replace directly, easy to use
Specification:
Material: This morse taper drift is made from carbon steel
Hardness: between HRC48-53
Use for morse taper shank MT1 and MT2
Cone length: 107mm; cone width: 5mm
The total length: 140mm; handle width: 20.5mm
Weight: 76g
Package content:1pc morse taper drift
SR
2025-08-22 11:10:30
Correct size, used for removing chuck from drill press. It arrived sealed, lightly oiled, and rust free.
Rick's Auto Repair
2025-07-12 18:47:02
Works great
Chris
2025-05-30 09:45:44
I lost my original one and this is a great replacement fir the wen 4214
OZ4
2025-05-20 16:07:36
This MT drill sleeve is a little on the small/short side. It works but in some cases and depending on the bit I'm using, it barely taps the bit out. So far so good.
V. McMullin
2025-05-10 15:00:41
Drift came as advertised. I haven't used it yet but expect no problems.
JK Jordan
2025-04-01 13:25:39
I use morse taper tools and adapters and this simple and inexpensive drift works well. Sure beats reaching for a screw driver to release the inserted tool.
Troy
2025-02-10 12:58:24
its a piece of steel. not really sure how it could not do what its intended for. it works.
R. Keen
2025-02-01 14:16:30
I had been trying to remove the chuck from my drill press with a screwdriver and hammer, and it wasn't working. I ordered this tool, and within 5 strikes of the hammer the chuck popped out. Much easier with the right tool!
Kelvin
2024-12-16 12:16:45
Works as described
Recommended Products
