Your cart is empty.
Your cart is empty. Description:
Designed to replace cracked or damaged electric motor fan.
Engineering plastic blades can increase cooling system efficiency.
Used for all kinds of motors for heat dissipation or some water pump.
Made of high-quality plastic, modern-design, durable in use.
Plastic blades have good elasticity, and can moderately adjust the relative position of the blades in the process of high-speed rotation so that the blades have good balance.
Cheryl Cantu
2025-09-03 18:27:36
Worked perfectly
Doug
2025-08-13 10:34:01
Put this on an old Delta AP400 dust collector motor that was seized, after I bent the original fan off the arbor to repair the motor. This fits great, has a little flex, and pushes a lot of air over the motor case.
Janet M. Colbert
2025-07-09 13:55:07
It was so easy to replace the old fan with this part. A snap!!!
Benjamin Crum
2025-07-02 10:45:26
I used this to a replace a broken fan on an old motor. The dimensions were correct, the material is appropriate and the molding was pretty good. I did clean up some mold flash and machine down the provided spacer to get the clearance I needed, but these were minor things and particular to my installation.
Donkey kong
2025-05-16 15:11:55
I made the mistake of buying an air compressor from harbor freight. 4 months in the engine seized up. Took it apart and the fan blade melted in the center and then froze up sideways. I would say it wasnt tighten during assembly at factory. Anyways, I pried it off and put this blade on. Been going well a couple of months now.
Ron Nord
2025-02-24 18:52:58
Worthless….couldn’t get it tight enough…did not blow air…removed it and put it in the trash can.
Pen Name
2025-02-04 13:42:45
Modified this to replace jump house fan... worked like a charm.. good hard plastic durable
Fred1945
2025-02-03 11:03:37
I installed it on pool pump on the exterior “tail fanâ€Fit good on the shaft . But with Normal high RPMThe circular shape lost its round shape .Cheap materials plastic is not heavy duty PVCOver priced for the quality
daniel b
2024-12-02 15:48:20
bon
troiky
2024-11-30 13:16:04
great fit, hope rubber bushing for the 14mm size holds
Recommended Products
