Your cart is empty.
Your cart is empty.Emily
August 21, 2025
Quality product. But didn't fit back window. My fault for not checking.
Rip Torn
August 18, 2025
Perfect match for my 2002 4runner. Mine's the Limited, but the other 3rd gen 4Runner trims would match too. One 20' roll did the entire driver's door and 3/4 of the passenger door. Be sure to undo the floor strip and the one low dash trim piece. It takes a 10mm socket and the panel takes phillips. You'll also want to pop your column trim between front and back doors, but that just pops off with a good tug. The factory seals have no seam.Put your seam toward the lower front where it's less noticeable. When I did mine, holding the new trim out in front of where I was working seemed logical--but holding it so the new trim is nearly perpindicular/90* actually had the smoothest and quickest result.Good luck!
Chad Hicks
August 12, 2025
Had to trim to fit but it works great
Bill
June 4, 2025
I purchased this from a company said it fit my vehicle so I had someone put it on course had to cut it because it was too long but then once I got it on it did not fit did not cover up the whole cracks between the frame plastics covers but now I have to eat the cost Because it was cut and I cannot return it so I feel like I was taking advantage of because it stated it fit my vehicle, but it did not
Michael
May 1, 2025
It fits the back door opening on my 99 Suburban with 12 inches left over. Stopped the rain and wind from coming thru.
Rick B
April 24, 2025
what I expected. unfortunately, I'm waiting for springtime to replace. don't want to rush this replacement outside in the cold. so, I can't verify the quality nor fit yet.
Customer
January 23, 2025
It seals but leaves a gap it’s not a perfect fit for a 2010 GMC sierra
Nak
December 31, 2024
covered all minor leaks around my vehicle that old weathering not longer covered. easy install. although need to make sure the ends are sealed. if simply cut then rain or snow can enter into the opening from where it is cut. and will rust from within. use heat or alternate method to seal off ends after cut to size.
eugenio mosqueda
December 14, 2024
Fácil de colocar y es de un residente y buen material.
Recommended Products