Your cart is empty.
Your cart is empty. Valance Clips 3-1/4inch 6Pack Clear Plastic for Window Faux Wood Blinds Parts,Accessory,Components
The clips ONLY fit for 3-1/4 inch(83mm) wide valance.
Note: The clips can ONLY fit for the 3.25inch(83mm) width wood valance, CAN'T fit for 2.5inch(50mm) or 3inch(76mm) width valance. Please kindly check the size carefully!
Pamela
2025-09-06 19:19:56
These clips were a perfect fit for my blinds. Be sure to measure the back of your blind valence to get the right size. They are pretty easy to install but I did have to remove the blinds to slide them on. I was happy to find them because I have looked for replacements where blinds are sold and never found them. The hardest thing was trying to decide which one to buy on Amazon because there are so many and a lot of sizes. Finally I read in the description of the clips to measure the valence and not the old clip and I got the right size.
R. Sides
2025-08-22 16:36:38
This clip is as good as the original factory clip in every way, size, and sturdiness. Would buy again.
Bill
2025-08-13 14:29:58
Our blinds are 15 years old a few times out of the blue one of the valance clips just snaps and the valance falls. It's only happened twice but in both cases I replaced the clips with these quick .. easy and cheap fix. Just make sure you order the correct size.
India
2025-05-31 18:45:09
This are a little different but it work. Thank you.
Carlos O
2025-05-24 12:44:26
These were a perfect match for an original set that broke on its own. Must likely sun , movement, etc. They are good quality. Just make sure you measure correctly and order the right ones.
Jean C.
2025-05-05 15:04:09
To hold blind cornices in place. they were the perfect size and easy to use.
Trojansky
2025-05-04 12:48:22
Hardest part was figuring out the side release slots of the blinds in order to install these. Once you’re able to pull out the blinds assembly you simply clip these on. Easy peasy.
Jim Nachtigal
2025-02-05 18:20:56
I bought these to replace the existing ones. They were almost perfect and I had to remove a very small bend on the bottom to make it fit. The removal was easy and they now fit perfect. A hand file did the trick for the removal and nothing to worry about.Thanks!Jim
Recommended Products
