Your cart is empty.
Your cart is empty.Product Description
Ryan Fuller
August 24, 2025
The gas shocks worked great, took 30 secs to put on my UWS toolbox. Very pleased
Customer
August 22, 2025
Worked well, great fit for the job
Mlyn
July 26, 2025
Worked perfect to replace the stock original 180N Gas shock and was easy to replace. Works like the day I took delivery, the trunk holds and won't drop uncontrolled. The 45Lb Gas Strut is 200 Newtons it's impossible to tell the difference between 180N and 200N in this application. Go for it! Save hundreds of dollars don't buy it from dealer.The 10 inch 45 Lb/200N Gas Shocks Struts Lift works like the original parts for my2016 Fiat 124 Spider #8 BLUE LUSSO trunk lift.Item came with brackets but are not needed on the 2016 Fiat 124 Spider trunk's original hinge studs.
Kari
July 19, 2025
They seem well made and worked perfectly on my old tsc truck toolbox
arnold dunn
July 3, 2025
Great price.
gadget guru
July 1, 2025
My Fiat 124 trunk lid struts were getting kind of soft (and not holding lid up if there was a breeze blowing) and so I got these as a much cheaper replacement to OEM. Considered briefly one of many used struts on eBay, but used struts could just as likely be softer than new ones.The extended length of the 35 lb struts are about ½" greater than the OEM, but still fit (and raise lid a bit higher). The compressed length is also a bit longer but they still fit (If too long then you won't be able to close lid). I couldn't find the specs on my OEM struts, but the struts for the very similar Mazda Miata are 27 lbs. The ones I replaced measured about 25 lbs, so I suspect 30 lbs is close to new OEM for the Fiat.Replacement is quite easy and all you need is a small flat screwdriver to release the clip when removing the old one. The new strut snaps on easily over the standard 10mm ball stud mount. Once I had both 35 lb struts in place, the lid stayed up well and was quite easy to close. It didn't pop up by itself (didn't want that), but if you gave a bit of a nudge without holding on to the nylon pull strap I had previously installed on the underside of the lid, it would bounce up a bit too vigorously for my liking. So, I ended up using one new strut and keeping one old strut and it works great.If I had to do again, I would've bought slightly lower capacity struts for this particular application. But overall, a good value.
Steve Kelly
June 29, 2025
Working well
jerrodd
April 27, 2025
These were easy to install and worked well.
Mitchell
February 11, 2025
Box for truck tool box. Easy snap on installation and have been working perfect for over a year.
Tom Riddler
January 21, 2025
Bought these for the pop up windshield on my side by side and have had zero issues with them collapsing while off roading. Happy with my purchase.
Johan Fehr
January 12, 2025
Arrived on time.I installed these gas shocks in to my van conversion cabinets.Came with very basic installation instructions but they did not work for me, for the most part it would be difficult to provide instructions as each application varies.I made a dummy cabinet and did a few trial and errors until I came up with a proper way for my application.I didn't use the screws that came with the kit because they were not the proper screw for my application.I ordered the 10" 10lb/45N for my overhead cabinet doors and it was the perfect size because my doors are the shaker style panel doors and the are only about 5lbs.They work well and I'm happy with the product.I would have given it a 5 star if the screws would have been a better quality and maybe more installation instruction options.
David LeCunff
December 14, 2024
Was given a used aluminum tool box for my truck but struts were shot. Thought I wouldn’t find a replacement but decided to look around and found these and worked perfectly. Tool box is like new again!
Harmit Dhaliwal
December 9, 2024
perfect
Recommended Products