Your cart is empty.
Your cart is empty.Jess Braaten
2025-08-02 14:28:23
Great price. No leaks, fit great, great quality, shouldn't have any issues with them rusting or corroding. Just remember when you get new tires the tire tech may throw them out and put cheap rubber ones back on 😂
Marc C.
2025-07-17 21:49:45
Bought them for the Tractor after changing out a bad tire. They seem to be of good quality, sturdy, well made, no complaints. Since I was buying them for a tractor wheel, I thought metal would be the way to go.No problems at all so far.
Q
2025-03-09 10:50:56
Worked well on my new tires. Easy to install.
JB
2025-03-05 16:34:41
Bought a four pack got a three pack but luckily for me I bought them for a supermoto dirt bike so I only need two but great quality and for the price I can't complain that much it looks like I am the only one who has gotten only three but it seems good and 'm ok with it still better than a rubber one
BURT
2025-02-05 09:23:26
Thanks to Jason's (JM) brilliant review on October 8 2011, I bought a 4 pack of these TR-416-S valve stems to make it easier to pressurize one of my sprayers, and since I had three to spare, I then went to town and installed a valve stem in ALL 4 of my sprayers. Use a 15/32 drill bit for best results (see pictures for the best location), and there will be no need for silicone or other sealants, although it can't hurt! After pressurizing to 35 psi (use a gauge!), I was AMAZED at how far I could spray and how FAST I finished the job!WHAT A DIFFERENCE INSTALLING THESE SCHRAEDER VALVES made- thank you, JM!Very easy to install, and they are an excellent value. I also purchased an Amazon air chuck and an inexpensive "Hotdog" air compressor from Harbor Freight for a complete package.
Wayne j.
2025-01-16 14:32:42
Looked perfect to me. Nice pieces
Q. Tran
2025-01-03 12:48:20
i use it for a hand pump sprayer. Drill a hole, install the valve, pressurize it to 30 psi...no more pumping by hand.
Smiddy
2024-12-19 10:20:59
I bought these to modify a new fuel can, to add a vent mechanism. I drilled a hole just under a half inch in the can, and then deburred it with a sharp edge. I then installed from inside using a coat hanger to support it. Once installed I removed the valve core. The cap does have an inner sealing material in it. This worked for me in this application. I sure it's not recommended, but it's now better for my purposed. I did not try using these as intended on a wheel yet. The fit and finish on these pieces is very nice. I'm sure they would work without issue on the intended application. Not Junk!
Recommended Products
