Your cart is empty.
Your cart is empty. Your Factory Antenna Base worn-out, brittle or cracked? Antenna Snap off going through the car wash? Lost your AM or FM radio reception? This is a "BRAND NEW" HIGH QUALITY VOTEX Replacement Antenna Base and it is the perfect inexpensive replacement option to your local dealer. VOTEX antenna bases are a Perfect Fit, High Quality and Extremely Durable that Meet or Exceed Original Equipment Specifications. This base is the Updated Version, meaning it has a 7mm stud instead if the 6mm stud that breaks so easy. So if you have a original 6mm mast you will need to update it to a 7mm mast. Any questions or concerns on any of our products feel free to contact us by telephone or email by clicking on AntennaMastsRus about us page here on Amazon.
Fitment:
Is Compatible with 1999-2006 Chevrolet Silverado 1500/2500/3500
Customer
2025-09-03 10:48:31
Good fit, slightly longer than original which us helpful.Install is a pain and could not get the rubber grommet completely through the hole.
Mack
2025-08-24 11:26:04
Shipment was quick and right stuff for my repair.
Customer
2025-08-08 15:56:20
30 minute installation, follow directions and it will work as it should. Saved have to fish a another cable to the radio inside the cab. Would buy again
Rick J.
2025-07-15 10:41:22
It fit perfect on my 1999 silverado 1500 thank you 🆠🆠ðŸ†
K
2025-07-14 09:47:03
So I installed this antenna base to come and find out the factory antenna does not fit. As well as my trim piece does not fit w/ an aftermarket antenna or an adapter to make the OEM antenna fit.
PASSTHEAMMO
2025-07-05 14:27:04
I read another review before typing this one that mentioned the base coming undone when screwing the antenna on - I ordered this anyway and bench tested it with good readings. It is longer than the original OEM which I believe is used in newer models - 10(?) inches extra isn't going to be an issue but it was not OEM length. After the hour to get it ran in place and hooked it up I screwed the new antenna into it and the base started spinning with the antenna. The internal solder connection was over heated/soldered and half burnt through. I was tightening by hand and had the antenna about half screwed down when it started spinning with the antenna. I went to unscrew the antenna off of it and the internal screw and housing came out with the antenna. Instantly sending me into a new realm of "unhappy" I have not been in for apparently too long. I unscrewed the antenna off of it and screwed/pushed the base back down. It had a decent connection but wiggling it would start walking apart and I know driving and wind would cause it to come out of the base and fall off the truck and lose the new antenna in the process. I had to pull this one out and order another antenna - by model number sold and shipped by Amazon that was the actual OEM length and went together with no issues. I don't think the extra length or quality was bad - just got a bad one like somebody else did.
Brad c.
2025-03-26 17:03:43
Fit perfectly with fast delivery
J. L.
2025-01-27 17:42:35
Sturdy. But needed 7mm to 6mm attachment to attach antenna head.
Recommended Products
