Your cart is empty.
Your cart is empty.
Note: It is recommended to use this spindle for wood carving, as this can improve the service life of the bearings
specification :
●Material: The cover is made of stainless steel, and the water jacket is high compression casting aluminum tube, red copper coil
●Bearing: 7002 bearing (2pcs), 7000 bearing (2pcs)
● Voltage and rated current: AC 110V, 7.2A
● Max Rotation Speed:10-24000 RPM
●Radial runout:≤0.025mm clamping mandrel vibrates at 30mm to nut
● Frequencies: 400Hz
●Size:65*195 (mm)
●Collet:ER11 collet, 6mm is standard
●Nut model: ER11-A(B)
●Cooling way: water cycling cooling way
●Lubrication way: high temperature resistance grease lubrication
●Power interface: YX20 water proof aviation plug marked with number 1, 2, 3, 4. Number 1, 2 and 3 inter-faces are connected with inverter power U, V, W respectively. Number 4 is connected with earth wire
Sk8er dude
2025-08-27 15:45:23
Yes I would buy again
Frank Fowle, Sr.
2025-07-25 10:18:53
With a new bracket and a new support plate I replaced my old Bosch Colt router with a 2 hp Huanyang spindle on my Open Builds Lead 1010. It took a while to program it but the included manual had all the info I needed.
Gary D
2025-07-24 15:06:41
This is my second spindle. The difference, as in better, is remarkable. First, this spindle has an internal ground connection that is installed. The supplied cable end is well marked. Instructions were emailed prior to the arrival of the spindle. The spindle has a well finished exterior and I look forward to years of service.
Cruzer
2025-07-17 14:54:48
I'm giving this another try. My original was replaced after a year and 3 months (Thanks to insurance) I hope this last longer. Works great when it works. My other when started did not start to rotate without some help. So it was replaced.
Willard E. May
2025-05-14 13:57:19
I love everything about it and as I said in the title it is a very quiet machine ðŸ‘
dude
2025-03-05 16:31:11
I bought this spindle to replace my other spindle from another company that broke. Runs quiet on my cnc machine.
Bob B
2024-12-14 15:14:18
My original Huanyang Water Cooled spindle was just over a year old and only had fifty-four hours of use when the bearings failed.When the spindle was disassembled to replace the bearings, It was discovered that the spindle only had three bearings and not four as indicated.When the bearings failed, it damaged the front bearing retainer in the housing, so it would not be cost-effective to repair.Very disappointed with Huanyang Water Cooled Spindle Motor.Not just for the three bearings, but because I only had fifty-four hours of service on the unit and now I have to purchase a new spindle motor.The picture shown has the new bearings installed.
Roc
2024-12-09 16:25:25
I bought a few of these for a work project. I have no complaints with the motors at all.
Recommended Products
