Your cart is empty.
Your cart is empty.Product Description
Winka T10 194 Extension Harness Plugs Connectors Wiring Sockets for car 6Pcs
Material: Rubber + Copper Wire.
Voltage:12V-24V.
Compatible Bulbs:158 161 168 175 194 2823 2825 2827 904 906 912 921 W5W, etc.
Easy DIY installation, No mechanic required.
Heavy duty, High efficient, Heat resistant, Never melt.
Package include: 6 * Sockets (not include lights).
Please double check the picture above to make sure the adapter is the same as your stock adapter to ensure proper fit.
smit0057
July 22, 2025
I used this to replace some old bulb sockets on a dash cluster of an old tractor. The wiring to the sockets had been chewed on by rats, the socket itself which was completely rubber basically dry rotted . These were a tad smaller but they still fit tight enough into the bezel to work. A great replacement part.
Valerie Grider
July 21, 2025
Good quality and everything expected!!!!!!
AUSTIN
July 16, 2025
I purchased these to replace severely corroded sockets on my spyder headlights. After reading reviews i knew they used very small wires and were not quality product but in most cases worked. I have not installed these yet but if you are looking at these just know these use very small wire, the rubber is not as pliable as my original, and you should take care when inserting bulb not to break the contacts. I would also highly suggest filling the socket with dielectric grease before inserting the bulb to reduce corrosion as that is what happened to my original sockets.Overall they should work for my application however the quality is just ok.
Chad Drake
July 6, 2025
I use these for indicator bulbs on custom dash panels. and bright, 12v power, easy to use. So far, lifespan is great. No flickering.
Customer
May 23, 2025
Will work to use 194 bulb since I cannot find replacement other than replacing the whole fixture.
Customer
May 17, 2025
Used these to replace the failing corroded socket on a few old wall low voltage landscape lights. It does the job and accept most small wedge bulbs for automotive or led landscape bulbs but they are very cheaply made. The connector inside the rubber surround will crush with any small force like using a plier to insert it where you are going to mount it. I destroyed two getting them trying to get it into the light’s mounting bracket. The copper wires inside the wire insulation are also very thin and snap easily after you solder them.
James McKay
May 9, 2025
Perfect for the structural shape of the hand, when in the 'writing' position
Customer
March 13, 2025
Great product. Made my project function like it was professionally done
S13_Kronzo
March 1, 2025
I ordered these to run a custom LED harness to my cluster because the backlit display stopped working.These can be used for many different applications.Would buy again, but I still have a few left.
Customer
February 13, 2025
the quality isn't all that good
Mike Harvey
February 4, 2025
They fit perfect
Raynald Buteau
January 20, 2025
Bien et facile à utiliser
salvator bernardo
January 13, 2025
they work for 20 seconds and then went out the sockets turn into a jelly like texture and the socket prongs inside the socket where all distorted the gauge of the wire was very thin this was and application for a snowmobile rear driving lights that put out appox 12 to 14 volts the bulbs where led rated for 12 to 24 volts very poor quality and if there is a larger gauge socket l would be interested
Recommended Products