Your cart is empty.
Your cart is empty.You have an XS Scuba Thin Line Pressure Gauge (SKU's: XSSTLSPG or XSSTLSPGM) and want a protective rubber boot. XS Scuba's Protective Boot for Thin Line SPG t is designed for gauges measuring approximately 2" x 0.75" (5.1 x 1.9 cm) in diameter x depth, and is made from durable thermoplastic material with left , right side and top attachment points for a clip or lanyard. Protective boot is available in black or green for enriched air Nitrox identification.
Derek A. Peck
July 9, 2025
Works great with the Cressi Mini SPG. A bit hard to put on at first, but once it is on it is very protective and works great. I did have some issues with the bottom of the boot being too small for the gauge fitting but nothing a sharp razor knife could not handle. Bought a second for my wife's regulator setup.
Matthew Jones
February 10, 2025
I bought this for my cressi mini pressure gauge. After some slight modifications it fits nicely. I took a dremel tool and shaved a little from the inside and put a center hole in it as well as 6 holes in a circular pattern on the back for drainage. Overall a pretty good gauge protector
BORDET Fabien
December 26, 2024
Too thin (and also too hard plastic, very difficult to instal) and doesn't fit an Apeks tek gauge as it is too thin, not deep enough.
Recommended Products
