Your cart is empty.
Your cart is empty.YG-1 F4 series vanadium alloy HSS spiral flute tap for multi-purpose. High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance. Black oxide treatment adds lubricity and creates small pockets on the surface of the tool that act to hold coolant near the cutting edge. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. 0.625-inches thread length. Applications: Good for steel castings and forgings/heat-treatable alloy steels, free machining stainless steel, heat and corrosion-resistant stainless steel/valve stainless steel, aluminum alloy castings. Excellent for low carbon/free machining carbon steel, medium to high carbon steel.
Mako Sather
2025-08-30 20:08:24
A quality Tap, cut threads as advertised.Worked well for my need.
Customer
2025-08-29 13:30:04
Very sharp, cut threads like butter.
James
2025-08-09 11:50:45
It sure did a nice job power tapping on a Bridgeport in 0.5†7075 aluminum. No issue at all.
Jason
2025-07-28 18:56:07
Taps arrived dull and did not cut.
3531Anonymous654
2025-07-26 18:13:29
Easy cutting and beautiful chip extraction. These are sharp, good quality taps.
Gary S
2025-07-10 21:10:47
Where have you been all my life?? Whereas standard taps leave debris in the flutes, these guys eject the cuttings in a couple of fine coils as you drive the tap. It is much easier to drive the tap straight through without stopping to clear it. No fuss - no muss!
John Ragozzino
2025-07-09 21:17:58
Threads like butter, but it took 3 orders to get the right one.
J Lloyd Hatfield
2025-07-06 10:13:17
Great tool
Mako Sather
2025-07-03 21:08:46
A quality Tap, cut threads as advertised.Worked well for my need.
Customer
2025-06-23 17:27:35
Very sharp, cut threads like butter.
James
2025-06-16 12:53:22
It sure did a nice job power tapping on a Bridgeport in 0.5†7075 aluminum. No issue at all.
Jason
2025-05-30 13:06:44
Taps arrived dull and did not cut.
3531Anonymous654
2025-05-23 16:19:37
Easy cutting and beautiful chip extraction. These are sharp, good quality taps.
Gary S
2025-05-11 16:36:34
Where have you been all my life?? Whereas standard taps leave debris in the flutes, these guys eject the cuttings in a couple of fine coils as you drive the tap. It is much easier to drive the tap straight through without stopping to clear it. No fuss - no muss!
John Ragozzino
2025-04-27 14:20:20
Threads like butter, but it took 3 orders to get the right one.
J Lloyd Hatfield
2025-01-24 16:43:33
Great tool
Recommended Products
