Your cart is empty.
Your cart is empty.YG-1 F8 series vanadium alloy HSS spiral flute tap for multi-purpose. High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance. Titanium nitride coatings add a hard layer of gold-colored ceramic to the surface that extends tool life and permits faster cutting speeds than uncoated tools. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. 0.625-inches thread length. Applications: Good for steel castings and forgings/heat-treatable alloy steels, free machining stainless steel, heat and corrosion-resistant stainless steel/valve stainless steel, aluminum alloy castings. Excellent for low carbon/free machining carbon steel, medium to high carbon steel.
Jor El
2025-08-09 11:47:20
This tap was just what I needed. I was tapping a shallow hole just a little deeper than the bolt needed to be. A regular plug tap didn't cut threads as deep as I needed. This one was perfect. Cut threads very close to the bottom of the hole. It was sharp and cut nice, clean threads.
Mark Mays
2025-05-13 17:59:56
very nice tool and great seller
Badcoyotee
2025-03-19 14:26:30
This is small and sharp. Use it very slowly with a little lubricant and success!
Ellen Murphy
2025-01-02 13:41:53
I tried tapering the hole I had drilled, with the recommended size hole pre-drilled, the bit got chewed up and is no longer functional. Disappointed.
James Wegener
2024-12-20 14:29:10
Love it, not a lot of holes tapped with it yet so I can't speak to tool life but love the performance.
Recommended Products
$52.95
$ 24 .99 $24.99