Your cart is empty.
Your cart is empty.Easily conceal and beautify Imperfect seams on cabinetry and face frame projects. This bit will trim flush while adding a "V" Groove along the seam of two adjoining boards. For use with soft & hard woods, ply-woods, composites, laminates, plastics and some non-ferrous metals. Designed to provide precise, efficient cuts and extremely Durable. The enclosed ball bearing guide ensures smooth running. 1/4" Shank.
D.S.
2025-07-20 11:21:12
I don’t know about the longevity because we just got it, but so far so good.
Edwin D. Cardona
2025-07-15 13:03:10
But haven’t try it yet.
Rodrigo
2025-07-09 21:21:31
very good quality bit, it do the job perfeclty!
Sam
2025-06-19 16:24:37
From the first use this bit left lots of tear out. Just a short time later it apparently developed a warp in which caused the bit to bite into the side of a cabinet and destroy the face frame. Will NEVER purchase this brand again. ALL Yonico bits I have ever used were dissatisfactory. I’d be better off with a dull chisel and a blindfold.
SavvyBuyer
2025-06-06 14:04:22
Although it was not specified in the product details, I took a risk and ordered this veining bit hoping for the best. I wanted a very fine v-groove. The depth was labeled at 1/16", very good. However, the width of the groove was not specified and I should have used the relative spacing in the image to see it would be wider than 1/16". Turns out it is a full 1/8" wide (see unfinished wood photo), for some uses that might be acceptable. As you can see in the second photo (has finish) this was my expectation. After all that, I would still stay the bit was acceptable, in spite of the dimensions. The roller bearing ran true. I don't know how long it will last but it did cut quite well in it's first use. the price was right for the level of usage I intend. (PS. I might look for an over-sized bearing to reduce the depth of cut resulting in a narrower v-groove.)
Kim O. Populus
2025-05-02 21:38:55
The bit seemed stable enough until about 2 hours into using it to route cabinet edge, it broke in the blade itself. As I know it did not cost much, I decided not to try to return. Mostly glad it did not mess up my cabinet door.
Ðmazon Customer
2025-03-12 10:52:30
First time I used it the 1/4†shank broke may have been a bad one used other bits before and they worked fine, don’t know if I will order another one
Beth
2025-03-10 11:16:43
The bearing came off after second use.
Mark
2025-02-20 11:20:09
Very fast delivery, good value and product
ivy.
2025-02-04 13:31:24
works great
Recommended Products
$51.18
$ 24 .99 $24.99