Your cart is empty.
Your cart is empty.GM Application Specific: This drive socket is designed for use with other automotive suspension tools to service the car shock absorber on an X or J body type GM vehicle
Harold H.
2025-07-20 17:52:20
Great value
Gregory Anglen
2025-07-10 15:31:18
It was a little larger than the actual nub on the top of my struts (08 Mazda CX9) but it did get the job done. On removing the old struts the nubs both snapped off, but I am assuming that was due to the strut not the tool. That said it was a pain to get the old ones off, but the tool worked perfectly for installing the new ones (NOTE: you have to run your ratchet in reverse since you are actually spinning the shaft and not the bolt… shaft turning left makes the bolt tighten right).
Randall Brewer
2025-06-17 17:27:28
Fits some of them
Customer
2025-05-27 12:48:14
bought this tool to replace the shocks on my Isuzu Trooper. It worked on the Old man Emo shocks but would not fit the KYB's.
IMan
2025-03-01 14:47:58
The media could not be loaded.
Andrew D
2025-02-23 18:55:43
Perfect and a must have if you're doing your own shocks
JM
2024-12-11 17:31:59
This socket does not fit Monroe front shock piston tip!
Recommended Products
$29.70
$ 15 .99 $15.99
$56.50
$ 25 .99 $25.99