Your cart is empty.
Your cart is empty.Product Description
- Step1
- Step2
- Step3
- Step4
frank e stone
2025-08-22 20:56:42
Fits great , looks good, great price, easy to customize
Bevis
2025-08-17 13:45:46
These things work great IF you buy the right hole saw for them.DO NOT use a 2" hole saw or the hole will be too big and sloppy.When you order these, also order thishttps://www.amazon.com/gp/product/B07R8YFZWF/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1This is a 1-31/32" hole saw (50mm)Make sure to use the drop down menu for size and choose 1-31/32" (50mm)This will give you the perfect size hole for a nice interference fit.You can smack them in with the heel of your hand and they fit perfect !I used a caliper to measure these grommets and then converted the thousands to fraction and millimeter.I then ordered the above hole saw and the fit was perfect in a 1" thick plywood workbench.If you try to use a 2" hole saw, you wont be happy with the results.These are a great value for the money IF you have the right hole saw.The seller should not be claiming that they are for a 2" hole because they are not.
goodhubby
2025-08-03 18:59:13
My wife and I made an office work area out of IKEA cabinets and countertops. I purchased the 2 pack to run the monitor cables through one grommet and the mouse and keyboard chords through the other to ease congestion. They are smaller than I had envisioned which is the only reason I put a 4 rating. Do not make the same mistake I did and use a 2 1/8" hole bit. I thought it was a 2". NOTHING A LITTLE CONSTRUCTION ADHESIVE CAN'T FIX! AMIRIGHT!!!! :)
Customer
2025-06-28 19:37:37
Great product, nice design and color for a modern finish
Rev Rider
2025-05-15 11:03:37
Bought these to fish power cord and cables to TV I hung on the wall in master bedroom. Put one behind the TV and one just above the baseboard near power outlet. Smaller and less expensive than the outlet size boxes sold for this purpose. Very happy with result. One reviewer complained about hole size and fit. They work perfectly in drywall using a 2†hole saw. Neither too big nor too small. Since they are in drywall instead of wood, I used a dollop of acrylic caulk to “glue†them in place. Once this dries they are flat, tight, and in place for good. Great to have 8 spares from this purchase.
Katie Bevacqua
2025-04-20 12:36:08
Great brass colored wire grommet for desk! Nice small touch that elevates the desk that I built. Still in process of finishing it, so the picture isn't the best - but it's a beautiful brass color and a great value for the price.
Jerbear
2025-01-22 17:49:33
Placed this on my deck to pass a power cord through the floor and it’s looks great. fit the hole perfectly half holds the cord in place.
Graham
2025-01-19 15:02:36
Work well but… you’re going to want to put a screw in this. If use a 2 inch also it will sit loosely however it’s easy enough to throw a 16th inch hole in and screw it in.I used this for running holes through cabinets. They will never be seen however I like to have a good finish to my products. Therefore putting in a cheap grommet so no exposed particle board from the melamine will show for customers who like to inspect installations. You will never receive a complaint from a customer if you utilize these in your work. I plan to continue to use them because of their low cost. I find a better price on a larger bulk item I will switch over to those. But this will work for now.
Recommended Products