Your cart is empty.
Your cart is empty.Product Description
TheDragon9750
August 9, 2025
Worked perfectly for my small project. I had to machine my own screwdriver to remove the stock retaining screw on my Lee Enfield No.4 Mk1*. I ended up adding gun bluing to it and drilled a wooden file handle to use as a grip. It may not be pretty, but it worked great.
Jim Courchene
June 26, 2025
Very good
Giordano Paredros
April 11, 2025
Worked perfectly for my project. I needed a flat piece of steel I could use as an anvil for restore a knife sheath where the original "easy rivets" had decayed. I went with post and burr rivets and needed something long, hard and narrow as a stable platform to set the burr and peen the post stub. Worked like a charm. I beveled the edges of the bar so it wouldn't cut the leather, the sheath and bar rested on a bench block. I started with a 2lb baby sledge, later got a rivet peening hammer. I ran the bar into the sheath so I could attach the flap of the belt loop back into the back of the sheath.
Steve H
March 22, 2025
I really enjoy it when I receive metal stock that's virtually ready to be cut, powder coated, or finished. This is it, precut with highly accurate dimensions, all cuts are 90° as to the order, no scaling, no rust preventative ( except mild oil,grease coating) plastic wrapped, & ready to be cut.This was cut, shaped, & powder coated for a pair of ballscrew bearing end mounts. I used one edge of the precut as my finished edge. Very happy!Steve
Eugene Evgenevich Kashpureff
March 8, 2025
Good piece of metal stock, delivered quickly to my front door cheaper than my local hardware store. Drilled and bolted easily, using it to reinforce an old car trailer. Recommended if you need a piece of steel.
Celine Verdiales
February 17, 2025
good quality, fast shipping,
Southcross
January 1, 2025
needs no food, magnetic things stick to it, it does however need constant play/activity otherwise it....its a steel bar what can I say? Need a steel bar? Are the dimensions correct for your needs? Are you sure? OK, then buy it, it is a steel bar
James
December 13, 2024
This is a nice piece of bar stock. No rust and clean cut at the ends. Not torched. If I was to be critical of anything it is pretty pricey.
Recommended Products
$34.09
$ 17 .99 $17.99