Your cart is empty.
Your cart is empty.Product Description
WisFan
2025-08-17 10:56:28
I bought this to fit around the bottom stair of our stairway which is curved at the base of the baluster. It worked fine in that application. I think we were at the limit of the radius this will fit as the first piece I placed around the curve ended up with a crease in it, probably from too sharp a bend. I was a little more careful when I wrapped the second attempt around it and it didn't crease. A little primer and paint and the step looks good.
raillink
2025-05-31 17:37:43
I used this on an end of a model train layout to make a curved backdrop. It worked great and bent down to the required 10" radius I needed. I had no trouble cutting it. I used a jigsaw down the backside in one of the precut grooves. Perfect for what I needed.
Rodney Mallette
2025-05-09 21:12:15
This is just a piece of 1/4" MDF that has been ripped every 3/16" to make it bendable. I expected it to be bendable plywood so I could make a prototype and maybe even a pattern. I do like using MDF and this was the worst case scenario because of those little rips.
Fosters
2025-05-04 12:46:18
This is ok, however I think you are better off making your own if you have a circular saw or a table saw. It is not all that flexible, and like others said, the kerfs tend to break away (as they are entirely too thin/many (should be 12 per 90 degrees, distance between depending on radius) The kerfs being too small - too close to one another and the material is too thin - causes the kerfs to not be able to touch themselves at the tips - and thus put too much pressure on the outer layer when trying to bend it as much as it should bend with so many kerfs... or for tighter corners.My project was to bend it around a 23" diameter cylinder, for that it worked ok, and was basically drenched in glue to give it more strength. Your mileage may vary
skeeter stark
2025-04-23 20:09:34
Bendy will tolerate a fairly tight radius. Used to form doors on curved front dresser. Accepts veneer very well. Before always had to cut reliefs with cabinet saw. Great product Will use again if need arrises
Patty
2025-03-03 15:59:33
Tried to cut a 2" strip off of this thing and it disintegrated. All the little grooves went flying off. I can't imagine it getting any worse.
Steve
2025-01-14 13:37:41
Wobbly wiggle planks
Bell
2024-12-29 12:57:35
The description in the website is very bendableBut it is not. once I bend to a not sharp angle it got brokenI’m really frustrated and I had to pay for shipping
Recommended Products