Your cart is empty.
Your cart is empty. What is it?
Our quick connectors are made of Polypropylene,It adopts Push to connect technology, which allows users to connect and disconnect quick and easy without the need of any other tools. Ball valve gives full flow and positive shut off without leakage. Valve act is 90 degrees, full on to full off, with no seepage.It fits standard 1/4 inch OD plastic RO tubing, Copper, CPVC, PEX and PVC pipe or hose.
Where to use it?
Applications include RODI system,Irrigation System, refrigerator ice maker tubing, coffee machine etc. This quick connect fitting is are perfect for hooking up a kitchen water supply , it isolate water line without shutting off all the cold water to the kitchen. It will save you lots of work getting to replace your in-line water filter without having to turn the water off in the basement or under the sink.You can also use it to run the RO System to the fridge ice maker.
How to use it?
Just pop in your 1/4 inch OD tubing into either end, pushing until it won't go in. To remove, just push in the outer circle on either end and pull right out. You need to make sure the tubing is cut squared to insure no leaks. For easier disconnect in narrow place, you can buy our disconnect tool by searching B079KQ7Q3B
What you will receive?
Ball Valve x10
J. Dunlap
2025-08-14 19:32:03
For drip irrigation, these act as both a shutoff valve *and* a quick-connect coupler! I use them in my raised beds so I can quickly detach my 1/4" dripper assemblies from my 1/2" mainline when I need to work the beds. I can also swap between dripper and sprayer assemblies based on what I'm growing.I've had these outside for a year with no signs of degradation. We'll see how they hold up to UV over the next few years.
Stephen Strasser
2025-08-02 14:00:12
My goto source. These work great.Great value !
Brian
2025-06-24 18:09:23
I waited a few weeks as I use it for a countertop water filter and the mechanism on it is very easy to use. I had brought prior quick connect for the same amount of money at hardware stores and these ones are holding up way better.
XThunder
2025-05-29 14:51:11
They work well, but there are no C-locks to keep lines from pushing in and releasing. The locks normally come with this type of connector. They are plastic C-clips that slide in to keep the ends from releasing the tubing.Not a big deal, they are a good product for the price.
Eldon Evans
2025-05-27 16:05:08
Easy to install, good price, no leaks, seem well built
Customer
2025-03-18 13:25:49
They arrived on time in good condition. Haven’t installed any yet but they look like they’re good quality and a very good price!
Dev Gualtieri
2025-02-18 12:33:17
It took a while for me to figure out that all I needed for connection was to push the tube firmly into the hole. It's possible to remove the tubing by holding back the plastic while pulling on the tube. It was also easy to cut a tab to allow full circle rotation of the valve for a motorized pulsed airflow at a 10 RPM rate. The only complaint is that there are no screw mounting tabs. I haven't run the pulsed airflow long enough to determine longevity.
Customer
2025-01-15 11:51:15
Allows me to turn off water to drip lines as needed.
Customer
2024-12-18 14:55:32
Very cheap material. Need money back . Broken in customer house ans me a flood over .
Recommended Products
$22.99
$ 11 .99 $11.99