Your cart is empty.
Your cart is empty.Product Description
Josh
2025-09-02 18:10:09
No problems at all
Charlie Van Landingham
2025-07-10 17:01:06
Product as described, we'll made, came will all hardware needed to install already assembled.
Lenny
2025-05-13 10:52:56
Nothing to dislike it worked for it intended purpose. I used it to build a trolly system in wy attic.
Customer
2025-05-03 18:13:55
Once installed, these work well to stop my hoist from sliding out the end of my unistrut beam. Installation is a little difficult but not really due to anything with this product. First, I had to look back at the product page for these since there were no instructions and, for some reason, I assumed the bolt would go through one of the holes in the unistrut channel. Nope, the bolts aren't long enough to do that. Once I got that part right the install was still kinda tricky because there isn't a good way to get a wrench inside the unistrut channel so the stoppers can be tightened in place. Like I said, that isn't a fault of this product, just the design of unistrut channel. This limit hardware is of high quality and once installed it should work exactly as expected.
Customer
2025-02-19 20:30:58
They work perfectly for attaching my heater to the ceiling
VF
2025-02-13 14:47:04
Although a simple screw and bolt could accommodate stopping the hoist, having a rubber stop makes it nice, without any noise or scratches. This is a must have for trolly hardware.
scott
2025-02-06 10:16:09
You may want to use a small wrench if you dont have it directly underneath the hole in the strut. It is effective.
TJ
2025-01-05 10:40:11
These stop the hoist trolley from leaving the track. Perfect fit.
Recommended Products