Your cart is empty.
Your cart is empty.Also referred to as 'Collet-Bezel Forming Tools'. Made from steel, the plate has 12 round conical holes a of which are cut into the plate at 17 degree angles. The punch is also made from steel, conical in shape at the end and cut to a 17 degree angle. Used for forming, stretching, reducing or changing the shape of a collet. Place the collet into the appropriate hole, insert the punch and tap carefully with a hammer. Collets should be annealed and gradually stretched or reduced. hole size approximately 4-12 mm. Plate measures 1.5 x 4 x .5 inch .
Karen
August 3, 2025
The punch is long so I have to put it on stump in a divet. But it works - I can’t use it table top
Karen
January 24, 2025
The punch is long so I have to put it on stump in a divet. But it works - I can’t use it table top
Recommended Products
