Shopping Cart

Your cart is empty.

Your cart is empty.

1-Channel 12V Relay Module with optocoupler Isolation Supports high and Low Level triggering (Pack of 10)

Free shipping on orders over $29.99

$13.99

$ 6 .99 $6.99

In Stock

1.Style:5v Relay


About this item

  • Convenience: The relay board is designed with 1 interface, humanized design, input and output terminals, and convenient wiring.
  • With indicator light: with power supply and working dual indicator lights. Power indicator (green), relay status indicator (red)
  • Insulation design: The relay board is insulated with a patch optocoupler, and the insulation circuit prevents the relay switching current from damaging the E/A port.
  • High quality: The module adopts normally open interface, high quality relay, the maximum load of the relay module: AC 250V/10A, DC 30V/10A.
  • Wide range of applications: suitable for all kinds of single-chip microcomputers, and can be widely used in various power control occasions.


Specifications:
Material: PCB
Control signal: TTL
Trigger current: 5mA
Operating voltage: 12V
Maximum load: AC 250V/10A, DC 30V/10A
Maximum Switching voltage: 250VAC, 30V
Trigger voltage: 0-1.5V (LOW); 3-5V (HIGH)
LED Indicators:
Power Indicator: Green
Relay status display: red
Relay output: 1. NO: The relay is normally open, the relay is suspended before it is closed, and it is short-circuited with COM after it is closed. 2. COM: relay common interface 3. NC: The relay is normally closed interface, the relay is short-circuited with COM before it is pulled in, and it is left in the air after it is pulled in. Package includes:
10 x 1 channel 12V relay module with optocoupler.


Reviews
September 4, 2025
Great and reliable relays if you are working with Arduinos. I haven't had a single problem in the 6 months of using these.
Nick Robertson
August 21, 2025
nothing wrong. great deal.
mike aita
August 1, 2025
to power up connect to v+ and v-. then you must apply a trigger to operate the relay. this 12 v relay triggers with 5 v or 12. this is perfect for my application with an Arduino.
Don Matz
July 9, 2025
The screw terminals are terrible. You have to bend them all up to get a wired in.
brian j paajanen
April 17, 2025
12v relay ive had no issues installed 3 so far and they seem to be doing fine. Good thing to have around if you like to tinker.
Eli A
April 16, 2025
Trigger config, screw terminals great unit
Dakota Carpenter
April 10, 2025
i tested 2 and they don't work. when the arduino triggers the relay, an indicator LED lights on so everything else is working. NC stays closed and NO stays open, i can only assume the switch itself is stuck.after reading the comments, some people had no problems, some had other problems. i'll test the rest that i already bought, but ordering from this seller is a gamble.
SA Construction
March 27, 2025
Notice that it’s missing the connectors on the left side where my fingers are. The purchasing picture shows connectors for both sides.
Ricardo A.
February 5, 2025
Muy práctico y hace la función que requería
Recommended Products