Your cart is empty.
Your cart is empty.Product Description
Danny Shaffer.
2025-09-04 11:32:44
Put it on right out of the box and it started right up works great.
Mr Particular
2025-06-14 14:15:42
Worked great for a John Deere 314 / Kohler K321 AQS.Contained the correct choke arm also.Just be super careful when removing the arm if swapping as there is a tiny ball bearing and spring at the far end opposite the arm, which will go flying when you remove. Put your thumb over the holes or put on some painter's tape.Great value. Tractor is purring again (if that's possible for a single cylinder)
MWBWMW
2025-06-11 15:09:24
Works good. I didn't have very good expectations based off of some other aftermarket Kohler carburetors but this one runs just the same as the factory ones I have. It does have a slight dead spot off idle but all the factory ones I have do the same thing.
Kevin Walls
2025-06-09 11:54:26
The best after market carburetor I have found. came with multiple choke rods one of wich worked perfict on My Cub 1650
user
2025-05-30 17:04:45
Doesn't work at all. Float needle doesn't shut gas off and floods it out within less than a second. Should have stuck with the rop shop
Thomas Raymond
2025-04-26 12:11:08
made to fit many motors so be prepared to change some moving parts to match your old one however it was easy. great price as the float, pin and seat cost more than this new unit. quick deliveryUnit fired right up with no additional adjusting to settings with the exception I lowered the idol
Ray Jensen
2025-04-20 15:40:02
Everything went well except for the tuning. It ran okay but you could close off both mixture needles and it would still run the same, a rough idle and a bit of a surge at mid to full rpm. There was also a vacuum leak on the throttle shaft.
stuckinnj
2025-03-23 18:53:59
Original carb was pretty much worn out. This was a great replacement. Less expensive than the replacement components to rebuild and a whole lot less labor. This was used on 48yr old Kohler K321
Richard Vandewiele
2025-03-10 18:40:50
Fit my 1970 ford lgt, kohler engine. Works good
Neil Mick
2025-01-30 10:45:42
Works good
Russ W
2025-01-20 17:08:24
had some small mods but works well. Support is good and helpful
andre
2025-01-18 11:49:42
parfait
mohamed mhal
2025-01-17 10:58:34
Dosent fit john deere 314 the choke cable is wrong measurement
Recommended Products
$68.18
$ 31 .99 $31.99