Your cart is empty.
Your cart is empty.Product Description
EASY INSTALLATION
1.Block the wheels and support the trailer ″A″ frame securely.
2.Remove the existing jack.
3.Install the Electric Tongue Jack using original nuts and bolts. Align the motor head so that the motor housing is facing the front of the “A” frame.
4.Connect the red positive lead to the positive terminal of the battery. Connect the black ground wire to negative terminal of the battery.
NOTICE
1.The diameter of the outer tube of your chosen jack, will need to match the existing hole size, or you will need to modify the hole diameter to fit.
2.Failure to block trailer wheels securely could result in personal injury and possibly death.
3.The motor will stall if jack reaches the full extent of travel both in retract and extend directions. There is an over load protection for the jack to shut off power that will auto reset in 15 seconds. After using jack, operator should learn the travel limit stops. The operator should stop the jack before reaching the travel limit.
4.If the motor should stall with the jack in the fully retracted position, and the Toggle Switch is not released, the motor will automatically switch off.
MOTORIZED OPERATION
1.Block trailer wheels securely.
2.The 3500 pound tongue jack for rv is operated by means of the Toggle Switch located under the motor housing.
3.Extend the jack by holding the Toggle Switch in the Extend position.
4.Retract the jack by holding the Toggle Switch in the Retract position. The jack is now fully retracted.
MANUAL OPERATION
1.Remove twist cap in the access hole. (located top center of the housing cover)
2.Insert the 11mm deep well socket (included) in the access hole, over the drive spindle tang. Rotate the socket clockwise to retract and counter clockwise extend.
3.When complete, remove socket and replace twist cap, and reassemble the fuse connection.
Sturdy Base Plate
Our electric tongue jack is equipped with 6-inch diameter quick extension feet plate gives you more stable support.
Vertical Trave
The height of electric trailer jack can be adjusted between 27.11-50 inches. The inner tube diameter is 2 inches, the outer tube diameter is 2.25 inches, working voltage is 12V DC, with a working current of less than 30A.
High Quality Construction
This 12V DC Power Tongue Jack is made from sturdy, corrosion-resistant steel, and can hold up to 3500lbs.
Alix
2025-06-21 15:09:58
Easy to install works good
traveller
2025-02-11 12:03:04
Failed within 1 month & zero warranty help from the seller.
Recommended Products