Your cart is empty.
Your cart is empty.Powercoil wire thread inserts are manufactured from precision Profiled diamond shaped stainless steel wire and formed into a Helical spiral. They provide high strength internal threads that resist the effects of temperature and corrosion. Their unique design ensures superior threads whose compound performance cannot be reproduced by any other single fastening method. They are much lighter and less expensive than any other equivalent Type of thread insert and because of their compact size they can generally be Incorporated into existing designs where no previous provision has been made.
Jeff P
2025-08-20 17:17:26
I'm very impressed with the quality of this kit.Shipping was instant too.I used it to replace stripped threads in an aluminum steering wheel adapter. Not only did it work flawlessly, the permanent repair is substantially stronger than it was when new.I'd also highly recommend using it on brand new threads in soft metals such as brass or aluminum to avoid potential issues in the future.After seeing & using this kit, I plan on buying a variety of other common sizes so I have them on hand.Buy this, you won't be disappointed.
SB
2025-08-10 12:54:01
Good sharp drill bit and tap. Spiral inserts formed perfect. Sturdy, well made installation tool and tang removal tool
Jeff Hankins
2025-06-27 15:03:03
Great product
Kenneth barnett
2025-05-22 15:39:12
Tap broke apart as soon as I started it in an aluminum 1/8†thick strap
Gen4ten
2025-04-16 18:43:16
Keeping all the components to a thread repair kit together is almost impossible, these little kits are invaluable for something you might only need once every couple years
dorsey perry
2025-02-26 17:43:22
Great tool to have in your box. Saves alot of maintenance time.
Derry K.
2025-02-18 18:38:31
I used this to repair corroded threads in a steel tube with walls that are not very thick. I followed the directions carefully -- there are a number of steps -- and it worked perfectly. It was actually kind of fun to install. If the coil is longer than the thickness of the material it is to be installed in, it is best to trim it a little before installation -- at the end that will be visible after installation, not the end deep in the hole. The near end needs to be flush with the surface, and if the far end is too long it could interfere with the last step, breaking off the tang.
Gary
2025-02-14 16:12:51
Do not know yet about steel, they worked very well in pot metal and cast aluminum use a good lubricant in those materials too avoid problms
Recommended Products
